91195281890 Kenmore Range - Instructions

The repair was so easy! If your stove is hardwired, be sure to turn off breaker as power is still going to the stove, even if the stove is turned off! Better yet, turn the power off to the whole house to be safe, then use a flashlight. After removing the two small bolts, pull the old element out, remove the two pull off leads, gently crimp the two leads, then slip them over the new element, push back in and reinstall the two screws. Thats it! Very simple!

turn electric off at breaker box . . . you could be electrocuted bt 220 voltage if you do not. Watch video provided by this site. That is all you will need

First, like my father, I have repair genes missing from my DNA. This repair, thanks in part to the video, was exceptionally easy. The only thing that did not work out according to the plan was that my range does not have a separate breaker in my service panel -- I had to use the main breaker. Since I work all the time, I started the repair at night and needed my hands free headlamp. I have a service panel and I plan to have the panel replaced and make sure that the range has its own breaker.

Took the back off the oven to get to the connection wires better. Took chanel locks and bent the ends of the element upward to clear the back oven guard

Undid bolts removed old element and then installed new one .

I watched the video in the website and in less then 5 minutes replaced the broken hinge with the new one and the door works perfect.

I pulled the circuit breaker then took the racks out took the nut driver and turned out the two medal screws then pulled out the coil very carefuly then i unhooked the wires bbeig careful not lose them i bent them and proceded to hook up the coil with no problem works fine bdwargo@ptd.net

The oven would not turn off. The heating element was red hot. Had to cut power to the stove to turn off the oven. After I restored power to the oven the oven would not work. I replaced the heating element & oven sensor. Oven work great.

pulled out the old one and just put the new one in after shutting down the electric 2 screws is all it was very easy.

1.)Turned off stove breaker in electric panel 2.)Moved stove and unplugged it 3.)At the back of the stove removed the clips from the bottom heating element 4.)Removed the stove door by opening it half way and pulling up, this makes it easier to reach inside 5.)Removed the heating element bolts 6.) go in reverse order to reassemble. Note: Took the time to give the stove a good cleaning.

Removed two screws holding the element in place. Carefully pulled the element from stove, as not to pull wires off element. Removed wires and installed new element.

It was not a repair, just a replacement of the element. Very easy and no challenges at all.

Turn off range circuit breaker; remove and save nuts holding old element; disconnect old element from wires; connect new element to wires; tighten new element in using the nuts you have kept. Turn on the breaker, turn on your oven. WARNING: INSULATION SHOULD BE KEPT AWAY FROM CONNECTED WIRES, OTHERWISE IT BURNS WHEN OVEN IS TURNED ON AND YOU WILL HAVE TO UNDO THE NEW ELEMENT AND PUSH THE INSULATION OUT OF THE WAY AND THEN REDO THE NEW ELEMENT.