91194491301 Kenmore Range - Instructions

remove two bolts in on sensor and slip thru back un plug and reverse to put in

First I unplugged the range. Then I removed the hex head screws, disconnected the two flag connectors and removed the old element. Then I reversed the process with the new element. I plugged the range back in and set the control to broil. It works like a charm!

When I found the partselect.com website, I was impressed by the fact that you could see the percentage of customers that the part fixed their problem. You can add me to the list of satisfied customer who will use you again. Thanks! Installation was easy, and shipping was amazingly fast.

Pulled unit away from wall with help of husband and followed instructions.

Just pushed on stud. Perfect fit, perfect match.

Ordered the new element (and two new racks since mine were over 10 years old) on Friday afternoon. Parts arrived Saturday! I was so pleased. All I had to do was unplug the stove, remove two nuts, pull out the old element, push the new prongs onto the clips, and replace the two nuts. Done. Works great and all parts were a perfect fit!! I will be ordering again when I replace the burners and drip pans!

Exactly followed the instructional video and my installation was flawless. Now the burners power up and function like new. The whole repair was smooth and easy.

Repair was very easy - less than a few minutes - just had to screw in 2 screws to the new drawer supports.

Used screwdriver to open door and Allen wrench to remove and replace glass.

This installation was for a replacement for one of the burner bowls on the original order. Replacement bowl fits proiperly.

Went super fast--very easy. Part fit perfectly and the installation was a snap.

Ordered part which arrived in 4 days. Removed range door (simple), removed shelves. With a power nut driver, removed support brackets holding element from top of oven. Removed screws holding element and temp probe at the rear of oven. Removed 2 wire connectors attached to element. Removed damaged element. Attached the replacement element to the 2 wire connectors and fed cables and probe wires back into the cable opening at the rear of the oven. Attached the new element to the top of the range with the existing screws. Attached the rear of the element with the temp probe with screws at the rear of the oven. Replaced range door. Plugged in power and tested for 15 minutes. Job complete. Parts price, great! Service call saved, priceless!

Removed the old element and installed the new one.

I pulled the range out, unplugged it, took the back off, unplugged the old terminal block and removed it. Attached the new block and ran the wires through to the back and plugged them in. Reattached the cover on the back of the range, plugged the range back in and pushed it back into place.

Pulled oven out removed six screws from the plate covering the wires pulled wires from end of element.Removed the two screws that hold element inside the oven. Removed broken element and installed new element.