Models > 91142676890 > Instructions

91142676890 Kenmore Cooktop - Instructions

All Instructions for the 91142676890
16 - 20 of 20
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Blew Out Infinite Switches and Selector Switch Due To Water Seeping Inside While Cleaning.
Turn off power from main panel that supplies unit. Basically, just pushed out the radiant cooktop from underneath (from the cabinet below) setting it aside on the counter, unscrewed 5 screws from each side which then let me pull apart the glass/ceran cooktop from the lower part (don't forget to remove the plastic knobs). Now I'm able to access the plate/cover in which the switches are attached to. After unscrewing the plate/cover (just a couple small screws on each end), I can now carefully one by one unplug the wire connectors from each damaged switch and attach to the new switch. Now, just swap out the switch and put everything back and you're good to go. It's really easy once you take off the glass/ceran top. You'll be able to see how they connect. Don't forget to turn the power back on.
Parts Used:
Selector Switch Surface Element Switch - 1900W SWITCH INFINITE CONTROL
  • D from Vallejo, CA
  • Difficulty Level:
    Easy
  • Total Repair Time:
    15 - 30 mins
  • Tools:
    Screw drivers
Was this instruction helpful to you?
Thank you for voting!
Cook top control stoped working
Just follow the directions on the website.
Parts Used:
SWITCH INFINITE CONTROL
  • Daniel from chesterfield, MO
  • Difficulty Level:
    Easy
  • Total Repair Time:
    15 - 30 mins
  • Tools:
    Screw drivers
Was this instruction helpful to you?
Thank you for voting!
Burner would not work
turned off breaker feeding electricity to cooktop, pulled cook top out of counter top, removed screws holding glass to cook top, removed knobs, replaced switches, replaced everything in reverse order. before re-installing glass I turned power back on and tested burner for operation.
Parts Used:
Surface Element Switch - 1900W Surface Burner Switch - 6 Inch- 1200W SWITCH INFINITE CONTROL
  • Robert from Plaquemine, LA
  • Difficulty Level:
    Really Easy
  • Total Repair Time:
    15 - 30 mins
  • Tools:
    Screw drivers
Was this instruction helpful to you?
Thank you for voting!
Element would not turn off
Set cooktop circuit breaker to off.
Remove hold-down straps from underneath cooktop.
Lift cooktop from counter.
Remove screws holding glass top to base.
Remove screws holding switches
Remove two screws holding element switch.
Move wires from bad switch to new switch.
Reinstall.
Parts Used:
Surface Element Switch - 1900W
  • NEIL from FRIENDSWOOD, TX
  • Difficulty Level:
    Really Easy
  • Total Repair Time:
    15 - 30 mins
  • Tools:
    Screw drivers
Was this instruction helpful to you?
Thank you for voting!
Dual burner was only heating on high.
Getting to the control switch was the hardest. Handling our 35" cooktop was tricky. The rest went fairly easy. Just make sure you make a diagram of the colored wires and where they go on the switch. We had to expand the holes in the switch a little to get the old screws lined up.. Putting the cooktop back together was easy.
Parts Used:
SWITCH INFINITE CONTROL
  • Claire from Altoona, PA
  • Difficulty Level:
    A Bit Difficult
  • Total Repair Time:
    30 - 60 mins
  • Tools:
    Pliers, Screw drivers, Socket set
Was this instruction helpful to you?
Thank you for voting!
All Instructions for the 91142676890
16 - 20 of 20
Back to Top