All Installation Instructions for LG Refrigerator 78032

old bushing worn and broken

removed the upper freezer door to access screws to remove lower door.
laid bottom door on its side, removed bad bushing, put new bushing in, put bottom door back on refridge, put upper door back on fridge. Door worked easy as when new. good closure of door and story..Happy customer, and wife even happier.....thank you....

Parts Used:

Bush

Jerry from CORSICANA, TX
Difficulty Level:
Really Easy
Total Repair Time:
30 - 60 mins
Tools:
Screw drivers, Socket set

13 of 21 people found this instruction helpful.

Was this instruction helpful to you?

Thank you for voting!

bottom door dropped slightly and bottom hinge area rubbing on steel door support

removed 3 fasteners for top door and placed freezer door aside, then removed 3 more fasteners on bottom refrigerator door and place that aside. replaced bushing on lower door bracket and reversed the above procedure to reinstall doors.

Parts Used:

Bush

Louis from PHILADELPHIA, PA
Difficulty Level:
Really Easy
Total Repair Time:
30 - 60 mins
Tools:
Screw drivers, Socket set, Wrench set

6 of 9 people found this instruction helpful.

Was this instruction helpful to you?

Thank you for voting!

Came without screws

Screws into handle with tool once I located the screws which took most the day...
Disappointed with your employee for not acknowledging that screws were required and needed to be added to order...

Parts Used:

HANDLE ASSEMBLY

PATRICIA from FORT MOHAVE, AZ
Difficulty Level:
Very Difficult
Total Repair Time:
More than 2 hours
Tools:
Socket set

2 of 2 people found this instruction helpful.

Was this instruction helpful to you?

Thank you for voting!

The ice maker in freezer P/NO 5988JA0002Y would leak water and make giant ice block

I ordered and replaced the ice maker. To replace:

1. Go behind refrigerator and unplug electrical cord and turn off water supply.

2. In freezer locate electrical plug for ice maker. It has two tabs on the left and right side of it. Lift the tabs and pull the plug to disconnect it.

3. Remove the three screws, 2 on top and 1 on bottom of ice maker You can actually leave the screws in place if you loosen them sufficiently and lift the ice maker off of the screws and washers.

4. Install the new ice maker using the screws and plastic washers to secure it.

5. Plug the electrical connector for ice maker into the receptacle. Note: The plug only goes one way and is keyed with different shaped plugs and holes. The wires on my plug naturally fell upside down so I had to turn the plug 180 degrees to make it fit in the slot.

6. Turn on water and check for leaks.

7. Plug back in refrigerator and you should have ice in less than 12 hours.

Parts Used:

ICE MAKER ASSEMBLY,KIT

Eric from SURPRISE, AZ
Difficulty Level:
Really Easy
Total Repair Time:
30 - 60 mins

1 person found this instruction helpful.

Was this instruction helpful to you?

Thank you for voting!

Replacing the middle door shelf on the refrigerator door

Extremely easy. Open the refrigerator door, remove all food items from the damaged door shelf and set them aside. Remove the divider by prying the back curved grip from the back wall of the shelf. Bump the bottom of the shelf with your hand in an upward motion until the shelf is dislodged from its mounting points. Remove the damaged door shelf and install the replacement shell by aligning the door mounting points with the groves built into the door shelf and press downward until the shelf is locked into place. Replace the divider and all the food items removed. Shut the door and you're done

Parts Used:

Door Shelf Bin - Clear