Quick Question!

Have you ever purchased from PartSelect.com before?

Models > 640C

640C Maytag Dryer - Overview

Get Parts and Repair Help for 640C

If you know the dryer repair part you need, you can browse the list of all parts on the 640C, or you can search by name or part description. You can also find your part by where it is located on the 640C by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your dryer. We’ve also included any installation videos we have for 640C parts. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

Search for parts
Keep searches simple, eg. "belt" or "pump". Need help?
$10.35

Adjustable Levelling Leg

Sold Individually. This adjustable leveling leg comes with a stop nut.

$49.88

Round Carborundum Oven Igniter

This round style carborundum gas oven igniter has an amperage range between 2.5 and 3.0 amps. Be very careful when handling this igniter as it is very fragile. Please note - this will not replace the flat style igniters. Also known as bake and broil igniter.

$62.52

Door Gasket and Flange Kit

This dishwasher door gasket and flange kit comes with a white door gasket, a flange, ten screws, and an instructions sheet.

$30.36

Indicator Light Kit

$4.89

WASHER

SCREW

$3.17

Nut

Oven Knob Kit

This knob kit comes with the knob skirt and attaching screw.

Drive Motor - 115V 60Hz

This motor performs 1725 revolutions per minute. This motor is used for some of Maytag's 06 series gas or electric drive blower model clothes dryers that use two belts.

$4.89

NUT

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

The lower burner would not ignite.

  • Customer: Mark from Rego Park, NY
  • Difficulty: Easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Screw drivers, Socket set
  • 61 of 65 people found this instruction helpful
First I removed the oven racks. Then I loosened the two screws in the back of the oven floor and figured out how to remove it. Then I loosened the two screws at the front of the diverter and, with some pushing and pulling and twisting, was able to get that to come out, too. Then I tried lighting the oven and noticed that the igniter was not glowing. When... read more

Leaky water inlet valve

  • Customer: Jack from Fort Worth, TX
  • Difficulty: Really Easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Nutdriver, Wrench set
  • 17 of 20 people found this instruction helpful
Easy. Removed screws at top holding dishwasher to counter. Turned off water to dishwasher. Unhooked water supply line. Electrical and waste lines were long enough to leave connected and pull dishwasher out, set on side. Pull off electrical connector. Use pliars to compress spring holding water line to dishwasher, remove that line from valve. Use nut d... read more

Stripped leveler screw making impossible to level my washer

  • Customer: Rebecca from Wylie, TX
  • Difficulty: Easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Wrench set
  • 13 of 17 people found this instruction helpful
Put blocks under the washer where the leveling leg was needed and screwed the part into the washer. Then it was just a matter of moving the washer into place and leveling. Pretty easy. read more