59675523400 Kenmore Refrigerator - Instructions

removed old bin and installed new

Remove screws holding pantry end cap to refrigerator and sliding bracket from pantry end cap, which holds deli draw in place. Remove plastic hardware from old to new, then replace screws in reverse order of there removal.

very easy, my reading the reviews i knew exactly how to do it, and it really didnt take 15 minutes. hardest was taking all the shelves out, but i had that all done ahead of time. as the part came very fast. perfect job and i did it not my husband. great company. i will diffently order from you again carol in beverly hills fl

remove old replace with new part easy as that no brainer

Followed the video as a guideline. It was not exactly as portrayed. My husband and I, being long time do it yourselfer's, were able to get around the differences. There were screws, instead of tabs as pictured in the video, plus had to remove 4 screws instead of one to loosen the old icemaker. After 2 days the icemaker is pumping out loads of ice.

Pins holding the door in place are part of the plastic end cap on either side of pantry drawer. Very easy to replace. Need only to remove two bolts holding the broken end cap in place, remove the drawer slide from that piece by removing two more bolts, reinstalling the drawer slide on the replacement end cap, and reinstalling the new end cap. Part was surprisingly cheap and arrived much sooner than indicated.

I actually hired a handyman who easily performed the repair

Removed crisper drawers, removed glass shelf and deli drawer and cover. Remove screws holding the sliding attachment and pantry end. After taking the old pantry end off I noticed that there was a plastic insert that went from the front to the rear, made a 90 degree turn and went to the rear area of the unit and was used to control the temp in the deli drawer. Took a little while to figure out how it worked and finally put it all together and reversed all of the steps taken to replace everything. Once I figured out the temp control slide it was easy to get it back together.

Looked at questions, picked one that applied, ordered suggested part, fix was super easy after watching video, Frig in running, part fixed it. Very excited, Thankyou.

Lift out the old door bin and replace with the new door bin. Very simple job.

Unscrewed the old filter and screwed in the new one

One mnorning the temp on the frig was in the 50's and the freezer was cold. Tried to get someone to come out and repair with no luck. We purchased a new frig. Then I decided to see if I could repair the old one to use. I wish I had discovered partselect before I bought the new one. First I thought from the web site that it was a overload/relay problem so I ordered it and changed it out and it was very easy. Then that did not correct the problem so I checked further and discovered that it could be the defrost heat element and thermostat. On partselect web site I saw where if your coil is covered in ice that this could be the reason. I ordered them and watched the video of how to change them out. The video is a little misleading because chances are you will not have the room around the coil that it shows on the video and also the element and thermostat will not come as one unit as shown on the video. It is still easy to cut the wires ont he thermostat and install it. The heat element is a little tricky to get out and back in and the clips that holds yours might be a little different and more difficult to do than the video but you can do it. All in all I spent about 160. 00 And the frig is working like new.

I had ordered some other parts for something entirely different off your website and service was great. So after almost ten years of a dark refrigerator, because of a defective switch, I decided to see if you had the part to fix it... You did and the part got here in 3 days. I had a working light switch and all the light in the world where my husband needed it most (in the fridge). It took me at the most ten minutes to replace the part. All is well now and I have a happy husband who can find the leftovers just fine. Thanks for your great service!

Diagnosed problem to failure of evaporator motor. Other stories on line at PartSelect helped to confirm this was going to be the right repair. Ordered the parts, recieved in a couple of days, installed them and all is well again. Side by side fridge and freezer got a deep spring cleaning as a bonus.

I was impressed at how fast the delivery came. Move refrigerator,cut off water & power, detach &* reattach part and test.