59673503200 Kenmore Refrigerator - Instructions

Take filter out of the box and open the refrigerator. Open the housing in the frig that holds the filter and twist the light-blue piece 1/4 turn, counter-clockwise. (Put the light-blue piece in a safe place.) Take foil away from filter. With 1/4 turn in the clockwise direction, twist the filter into its position. Let five gallons run through the system to get fresh, filtered water.

Followed your video instructions and tips. Real easy

Getting the old ice maker out was not difficult - it sits on a small ridge built into the freezer and then it takes three screws to attach it to the side of the refrigerator. Three important things to remember: (1) take off the metal bar that shuts off the ice maker from the old part, the new part doesn't come with the bar; (2) keep the screws and the cap from the old ice maker as they don't come with the replacement part either; and (3) make sure you put the water tube back into the holder otherwise it will pour all over the freezer (and not into the ice tray).

Unscrewed the broken panel and replaced with the new one. Had to remove 3 drawers and shelves to gain access but found it real easy to replace the part.

Simply replaced cover by hand. No tools required.

I wasn't sure about the part I needed so I called the service number, they help me decide on the correct parts for my unit. This was the easiest repair I've ever done. One hex head screw and one clip in electrical connection and we were done. It took less than 5 minutes and now it works like new, no more leaking water and plenty of ice.

used the directions from PartSelect

simply repalced

I snapped the cover plate to the filter open. Pulled the filter down and twisted counter clock wise to take filter out. I installed the new filter in by inserting the filter and tuning clock wise to secure the filter. I flushed the water for about two minutes and then allowed it to be put back into service.

My son in law was able to take off the defective end pieces, and replace them with the new ones, in about 20 minutes. 10 minutes were probably spent in finding the right tools.Very easy to do. Parts were received within 2 days of ordering (I placed order on a Sunday).I was able to find the parts right away on your inter net lay out.

I simply followed the online instructions. Easiest repair job I have done. Once installed, which took about ten minutes, it was producing ice in less than two hours and is performing as it should. Had my frig not been a bottom freezer the installation would have taken less than five minutes. And to let everyone know, the on line instructions came in very handy during the removal process. Many thanks.

I ordered the replacement parts on line and received it a few days later. Thought I'd wait till the weekend to install the new parts. I expected it to take longer so I waited. Boy was I wrong. The hardest part was unloading the top shelf of the freezer. And it took longer to go get the nutdriver. I should have put it in immediately. Thanks for the instructional video. Works like a dream NO LEAKS. Will use your services on other parts as needed. Don from Pittsubrgh, PA.

Followed video advice

followed instructions step by step, everything went right in place and works perfectly. I could do it again inless time now that I seen what I was doing wrong on the back piece. (hope I don't have to) Thanks for asking.

I followed the electrical circuit and noted that both the fan and compressor were powered on a circuit that goes thru the Freezer Thermostat. Lights are on a separate circuit. Since neither the fan motor or the compressor were doing anything, I guessed the problem must be with the Freezer Thermostat. To test this I shorted the Thermostat and the fan and compressor started immediately. I ran the fridge in this mode for a few minutes to determine if it was cooling. When I was satisfied that it was, I ordered the Thermostat. Replacement took only a few minutes using a screwdriver and pliers. Fridge works perfectly now.