Quick Question!

Have you ever purchased from PartSelect.com before?

Models > 4KSRS27QDA01 > Parts

4KSRS27QDA01 KitchenAid Refrigerator - Parts

All parts for the KitchenAid Refrigerator 4KSRS27QDA01

Below is a list of all parts for the KitchenAid Refrigerator 4KSRS27QDA01. To find the repair part you need, you can browse the list below or you can narrow your choices by searching for a part by name or description.

All Parts for the 4KSRS27QDA01
1-14 of 361
Search for parts
Keep searches simple, eg. "belt" or "pump". Need help?
$6.30

Door Cam - Black

The lower door cam is also known as the closing cam or door closer cam and can be found on your refrigerator or freezer door. The purpose of the lower door cam is to lift the door ...

$23.78

Bi-Metal Defrost Thermostat

If you have ice building up in your freezer, or if your freezer is getting too warm during the defrost cycle you may need to replace the bi-metal defrost thermostat. The function of the defrost bi-metal thermostat is to clip onto the evaporator and protect your evaporator from overheating during the defrost cycle. If your refrigerator does not defrost properly you can test both the thermostat and the heater to figure out which part is at fault. For this repair, you will need a Phillips screwdriver, a 1/4 inch nut driver, a flat blade screwdriver, a pair of wire strippers, a roll of electrical tape, and a few butt splice connectors.

$3.02

Screw

This screw is sold individually.

$27.99

Ice Bin Auger Drum

This white ice bin auger drum comes with a washer.

$14.90

Door Closing Cam Kit

This door closing cam kit is intended for use with the bottom of refrigerator and freezer door hinges. The cam helps with the closing of the doors and to keep them slightly in pos...

$5.21

Icemaker Water Fill Tube Kit

The icemaker water fill tube provides water to the icemaker so it can produce ice and dispense water. If you notice that your ice maker is not making or dispensing ice, or is leaking, you may need to replace the water fill tube. This water fill tube kit comes with a fill tube and a compression nut. This part is made of white plastic and is approximately 10 inches in length. The ice maker water fill tube is in the rear of the fridge. To complete this repair, you will need a 1/4 inch nut driver and a utility knife. Before beginning this repair, you may want to disconnect the water and power supply to the refrigerator.

$6.38

End Cap Trim Piece

Sold individually.

$53.58

Ice Bucket

Bucket only. All other parts sold separately. This part holds the ice once it's released from the icemaker.

$17.49

Micro Switch

This switch is located inside the dispenser.

$30.12

Fan Blade

Used with Evaporator Fan Motors.

$12.75

Ice Dispenser Door Chute

*Please note, this door chute is no longer being manufactured with a heater.

$26.40

Shelf Support Stud

This is a 12 piece kit.

$28.84

Icemaker Shut Off Arm

When the icemaker shut off arm is high enough the icemaker will shut off and no more ice will be made until the level of ice in the bin drops. Also, the icemaker can be turned off ...

$3.02

Screw with Washer

This metallic screw is less than an inch long and comes with a plastic washer.

All Parts for the 4KSRS27QDA01
1-14 of 361