4KSRS25QFW00 KitchenAid Refrigerator - Instructions

Drilled holes where pins had sheared off. Replaced pins with 4-40 x 1" screws and nuts and fastened switches and spacers on bracket. Used Loctite threadlocker to prevent nuts from loosening and installed bracket. So far, both ice and water dispensers are working fine.

Removed front panel by inserting stiff putty knife at bottom and gently prying snaps loose. removed two screws holding electrical board. had assitant hold both out to one side without removing their connections or wires. Cut off old water line about three inches behind broken nozzle. Cut head off a small screw and used threads to connect cutoff old hose to new hose. Pulled both through door and out bottom until new hose appeared. Very easy.

I followed vidio instructions, took about 15 minutes. Fridge making great ice cubes again. Felt prouud of the repair I did being 70 years old and a female. Thank you

Unplugged refrigerator and shut off water supply. My husband took out the ice cube tray, loosened 2 nuts (?) and took out 1 screw. Removed the old unit. Set in the new unit and tightened the two nuts and replaced the screw. That's it! (Parts arrived in 1 1/2 days!)

Take off the old one and maounted the new one and get a lots of ice lol, thanks

After viewing video, took front cover off and found switch mounting broke. Ordered part through the online selector, which worked great. Received the part in a timely manner. Replace broken part, working great.

Bought a replacement ice maker from Parselect. I turned off the refrig. removed three screws. Unplugged the ice maker from the refrig. It was easy. Installation was the reverse of the removal.

Replace complete Unit

After receiving the Control Bracket from postal Service & followed directions as outlined in online Viedeo, the total installation was completed in 20 minutes. The last time that the Control Bracket ice switch was broken I had a Handiman install the new Bracket and the total cost was $115.58; this time the total cost was $21and I have one extre Control Bracket for future break down,

followed the video and it went really fast.

Just like in the video. Just snapped it in! Thanks

Water was already off. All I had to do was pull the fridge away from the wall, remove two screws that hold the fill tube onto the back of the frige, then remove the fill tube. Install the new fill tube, reinstall the two screws. Had to cut the water line straight and clean, slip on the new Compression nut and farrell and insert into the new fill tube, tighten-up, good-to-go.

After reading (Warm air getting into freezer) by David from Chesterfield, MO & (Ice door was broken) by Ray from San Antonio, TX, it was easy to follow their instructions (especially- Patience is a virtue! and go step by step. Thanks to both for their detailed instructions, this retired mechanical engineer was able to 'get it done'. Stan from Denison, TX

pulled crisper drawer out plus drawer above. Removed old bracket & replaced with new part. Put drawers back in. Part was exact fit - no modifications required. Time was actually less than 5 minutes.

removed both drawers, glass. lifted old part up and out. set in new part. replaced glass and drawers........