3ZMED5705TW1 Maytag Dryer - Instructions

Followed the instructions that came with belt everthing went just fine.

removed old screen and replaced with new one.I would like to add that PartSelect was the only place i could find the part at a reasonable price, and that it was delivered in record time.

I replaced the entire motor in the dryer and the belt while I had it open and it is working great! I just watched the short video on the site to learn the tricks and did it myself.

My dryer had been continuing to run when I opened the door for a couple of months. Then one day after drying 3 loads it refused to start again for the fourth. I googled the problem and found some you tube videos for replacing the door switch. I was having trouble popping the top of the dryer open and one video had the key information to push the top forward from the back. Unplugging the old switch was a bit difficult, but plugging the new on in is easy. Put everything back together and my dryer works again.

I watched the attached video that was with the belt I ordered and it took less time to do the repair, then it did to watch the video. The video was very helpful.

I followed the instructions just like in the YouTube video. The video was awesome! Well lighted, good audio quality, and perfectly illustrated all the steps involved. I had already tried taking the switch out, but I couldn't figure out how to release the clips on the front. The putty knife was just right. I'll definitely be using you guys for any future appliance repairs!

Trouble shot to failed motor. Ordered motor and new drive belt. The hardest part is figuring out how the dryer dis-assembles. Follow Parts Select on-line instructions. Also, several good instructional videos on You Tube! My recommendation is to order a new "blower wheel" when changing motor on a gas fired dryer. The heat combined with age bonds the blower fan to motor shaft. It had to be broken off in pieces to remove motor.

2 screws at lint tray 2 screws on back pick up top 2 screws in front under top lid separate front from drum slip in new belt screw front back to top route around tension pully put other 4 screws in complete so dry something

Popped top up Took front panel screws out. Looked for other damage. Put belt around the tumbler and got it hooked up. Grew an extra set of hands and re assembled front the checkd seals to make sure they where on and put top back down... Process is a pain in the butt i reccomend socket set channel lock pliers and a cold beverage or two

Removed top and front panels, lifted front of drum, slid new belt on drum then thru tension and motor pulleys. reassembled.

took out old put in new

Simply changed the designated parts according to instructions.

quite simply I followed the path that was worn from years of use. it was very apparent the belt had broke. along with the belt there was a generic diagram for proper install. this was very helpful

Opened dryer top, disconnected door wireing, took off front panel, laid dryer on back, cleaned out lint and inside, put new belt on, and put parts back together. Dryer works fine now.

Remove Filter and (2) phillip screws. Use common screw driver to pry top from cabinet. Fold top back. disconnect door switch and removed (2) screws holding front of cabinet and lift frong slightly to remove from cabinet. Remove broken belt and discard. check rollers for freedom and placed drum on rollers. guided belt through idler and around motor pulley. lift front and placed on lower hooks. Lift drum and installed (2) screws that holds front of cabinet to main cabinet. connect door switch and check drum for freedom of turn. turn drum several times to get belt to center. Closed top and replaced (2) screws that hold filter door in place. Install filter and test run dryer. Completed job in about 38 minutes.