3RLER5437KQ0 Whirlpool Dryer - Instructions

open dyer door replace lint filter perfect fit, good price, fast delvery. thank you

Remove wire terminals, & four screws, install new parts. Very simple fix! This is the second time I've used Parts Select to fix my appliances. Very satisfied customer!

First I removed the front kick panel to observe the drum and blower to see that both were running. I watched the element inside the heat can as well, and saw that it wasn't receiving a current (no heat, wasn't glowing). First thing I did was test the element itself by removing it from the heat can, and with a multimeter set to its lowest ohm setting, touched both terminal ends to check for continuity. The MM read 0 so it was fine. I then removed and tested the thermal fuse and the relay on the blower in the same fashion, removing them and checking them for continuity. They were fine also. I then moved on to the thermal limiter and relay on the heat can, and that's where I found a broken current. After installing both parts on the heat can, I observed the element receiving a current and the problem was fixed. I've done several loads since then and it is drying better than ever. Problem solved, for now.

My way of replacing the pulley was much faster than the parts select video that showed how to replace the belt tension-er pulley. They took off the door, the entire front AND the drum to get to the pulley. I ACCESSED THE PULLEY BY REMOVING THE 4 INCH EXHAUST PIPE, (ONE SCREW) WHICH GAVE MORE THAN ENOUGH OPENING TO REPLACE THE NEARBY PULLEY! I suggest you remake that video