3ED27DQXFW00 Whirlpool Refrigerator - Instructions

Drilled holes where pins had sheared off. Replaced pins with 4-40 x 1" screws and nuts and fastened switches and spacers on bracket. Used Loctite threadlocker to prevent nuts from loosening and installed bracket. So far, both ice and water dispensers are working fine.

Removed front panel by inserting stiff putty knife at bottom and gently prying snaps loose. removed two screws holding electrical board. had assitant hold both out to one side without removing their connections or wires. Cut off old water line about three inches behind broken nozzle. Cut head off a small screw and used threads to connect cutoff old hose to new hose. Pulled both through door and out bottom until new hose appeared. Very easy.

I followed vidio instructions, took about 15 minutes. Fridge making great ice cubes again. Felt prouud of the repair I did being 70 years old and a female. Thank you

Removed old drawer, replaced with new one. Easy fix. New drawer fits perfect.

The glass cover came on time and in good packaging. I removed it from the packaging and slipped in to the shelf. It fit perfectly and was extremely easy to do. We are very pleased with the entire process. Thanks

After viewing video, took front cover off and found switch mounting broke. Ordered part through the online selector, which worked great. Received the part in a timely manner. Replace broken part, working great.

After receiving the Control Bracket from postal Service & followed directions as outlined in online Viedeo, the total installation was completed in 20 minutes. The last time that the Control Bracket ice switch was broken I had a Handiman install the new Bracket and the total cost was $115.58; this time the total cost was $21and I have one extre Control Bracket for future break down,

followed the video and it went really fast.

Just like in the video. Just snapped it in! Thanks

Water was already off. All I had to do was pull the fridge away from the wall, remove two screws that hold the fill tube onto the back of the frige, then remove the fill tube. Install the new fill tube, reinstall the two screws. Had to cut the water line straight and clean, slip on the new Compression nut and farrell and insert into the new fill tube, tighten-up, good-to-go.

In our new house we found that one of the wire racks supporting a slide-out glass fridge shelf was broken. The cylindrical support rod at the back we unglued/unattached. I tried to fix it with super glue (came apart), and then metal epoxy (worked at first, but shelf collapsed under load). A new wire frame fixed it with zero tools. Problem solved! Note: I had problems matching the exact fridge model at first. I contacted Kitchenaid support and they sent a pdf with every part labeled. It was then easy to find the part on PartSelect. I appreciate the high quality images that let me confirm the match visually.

After reading (Warm air getting into freezer) by David from Chesterfield, MO & (Ice door was broken) by Ray from San Antonio, TX, it was easy to follow their instructions (especially- Patience is a virtue! and go step by step. Thanks to both for their detailed instructions, this retired mechanical engineer was able to 'get it done'. Stan from Denison, TX

Fridge would stop cooling, get way over temperature. I noticed it would start up again if I tapped near the thermostat. It would run for a while then stop again. Replaced the thermostat exactly as shown in video. Fridge works fine now.

all is fine now. thanks andy

Found the part on the website (be sure to put the proper model number in)Be very watchful ofhow the bdracket come out and how the various wires go back onto the bracket. (Make a diagram on paper with colors in the proper location.