3ED22DWXTN01 Whirlpool Refrigerator - Instructions

fisrt i watched your video loosened two screws removed one removed icemaker installed new one tightened screws had ice in 2 hours i never shut the water off no need

Unscrewed three screws, inserted new part, completed in less than 10 minutes and my icemaker works!!!! My icemaker did not work for 2 years and after spending $58, my icemaker was back in action.

the online video on how to change out the part saved me tons of time and do it right.....keep those videos coming, also right part too and easy to find on your site

I tried to just replace the cover rather than the whole unit but it was impossible - the cover would not go/stay on. I tried to remove the old unit completely but it would not unplug it was practically fused to the back of the fridge and the liner was cracking. I ended up breaking the cover and jerry rigging it over the bulb to prevent items in the fridge from being able to touch. Bad solution.

I watched the installation video on "Parts Select". Unfortunately I watched it twice b/c the first part ordered last October only lasted 4 months. This part seems to be alright as the refrigerator has been running for approximately 6 days now - so far so good.

I was able to verify that the water inlet valve was ok based on shorting the test points as described in the online ice maker troubleshooting guide. I then ordered the replacement ice maker and received it within 3 days. The repairs went very smooth, remove 3 screws, unplug connector, transfer shutoff wire to new unit, connect power, replace 3 screws. Done. Ice bucket was full within 24 hours.

repair went well. Ice maker still not making ice. UGH

I watched the parts select YouTube video. The repair was a piece of cake. We now have ice again. The part was correct and arrived in just 48 hours. Perfect in every way.

Watch the video was very helpful. I'm just a women and I did it all by myself. Thanks for the help of the video.

I followed the instructions that came with the part. Less than five minutes it was good as new.

I watched the video on you tube and followed his instructions. It was very easy, it took about 20 minutes from start to finish.

Unplug refrigerator and turn water supple off. Remove three mounting mounting screws and unplug the old ice maker.(there is a latch on the plug to release it) Remove shutoff arm from old unit or if ordered seperatly with the ice maker, install shutoff arm on the new unit. Plug the new unit in (latch will snap into place when plug is properly seated.) Install the bottom screw (leave screws loose until all are started in the orginal holes). Tighten screws and you are done. Turn the water on and plug refrigerator in. After about an hour or two the ice maker will be cold enough to start making ice. In about five hours or so you will see the first ice cubes!!!!

I got the new part and unplugged the refrigerator. I removed the wire auto shut-off. I removed the old motor assy. I checked to see if the motor quit running at the same locations as the new one before removing the entire ice maker. Lucky it did, so I installed the new motor assy without having to remove the ice maker. It took 10 minutes at the most.

Verified that the sensors were working. After removing the Ice maker assembly from the sliding track, I found that the indexed drive wheel on the motor had broken off from the shaft mounting. I ordered the Icemaker control and motor assembly from Partselect and swapped out the bad part. It only has three screws to remove and replace so it's fast and easy to fix.

I watched the video and made sure my replacement ice maker matched the original. On my particular icemaker/refigerator combination, the electrical connection was slightly different than what was shown in the video, but the process for removal and replacement was very similar. I believe if more videos were available that were of the quality of the one on this website, there would be more people attempting to replace parts. I believe I saved over $200 by doing it myself. Kudos to the website and video people.