Quick Question!

Have you ever purchased from PartSelect.com before?

Models > 2DWTW4740YQ0 > Parts

2DWTW4740YQ0 Whirlpool Washer - Parts

All parts for the Whirlpool Washer 2DWTW4740YQ0

Below is a list of all parts for the Whirlpool Washer 2DWTW4740YQ0 - Residential, Automatic. To find the repair part you need, you can browse the list below or you can narrow your choices by searching for a part by name or description.

All Parts for the 2DWTW4740YQ0
1-14 of 121
Search for parts
Keep searches simple, eg. "belt" or "pump". Need help?
$48.05

Lid Latch Assembly

The point of the lid switch is for the tub to stop spinning when the washer lid is opened. It is a safety precaution just in case someone decides to stick their hand inside the wa...

$3.02

Hose Clamp

This hose clamp is used in a wide variety of household appliances. Most often it is found in washers, dishwashers, refrigerators, freezers, dehumidifiers, garbage disposals, or air conditioners. This clamp is used to securely attach a hose to another part of your appliance, which helps prevent leaks from those connections. Depending on the appliance, it can attach hoses to drain pumps, water inlet valves, pressure switches, and injector nozzles. We recommend you refer to model-specific diagrams for appropriate uses and exact placement. This hose clamp is made of metal, and is sold individually. To access and replace this part you will need a nut driver, pliers, and screwdrivers. Before you begin any repair work, make sure you have unplugged your appliance, and shut off the water supply if applicable.

$33.36

Clutch Assembly

$64.15

Suspension Rod Kit

This kit includes 4 suspension rods.

$50.87

Shift Actuator - 120V 60Hz

This part changes the transmission from agitation to spin mode.

$3.02

Lid Hinge Mounting Screw

Sold individually.

$9.64

INLET HOSE

This hose can handle hot or cold water and is five feet long.

$5.73

Washer

This part goes on the agitator retaining bolt.

$24.81

Strike

$5.51

Hose Clamp

The hose clamp is used to hold the water hose in place which will prevent the hose from leaking water. Sometimes the clamp may lose its ability to latch on, causing a leaking washer. For the installation, you will need a flat head screw driver to replace the clamp and a drill to access the screws to remove the front of the washer. Be careful if you do not have specific clamp pliers as the clamp could fly off. Once the front of the washer has been removed, take a quick look for water damage or any obvious signs of where the leak is coming from. If it is not obvious, run water to test.

$4.89

D-Shaped Knob Insert

This insert is sold individually. Knob not included. Knob is sold separately.

$12.10

Drive Block - 2 5/16" High

This part is for large capacity belt drive and direct drive appliances.

$6.12

Touch-Up Paint - White

This touch-up paint can be used on a wide variety of household appliances. It is most often used on washers, dryer, refrigerators, dishwashers, ranges, freezers, trash compactors, ...

$4.89

Lid Bumper

This gray and white washer lid bumper contains a rubber bottom and is sold individually.

All Parts for the 2DWTW4740YQ0
1-14 of 121