Quick Question!

Have you ever purchased from PartSelect.com before?

Models > 2536480240E > Instructions

2536480240E Kenmore Refrigerator - Instructions

All installation instructions for 2536480240E parts

These instructions have been submitted by other PartSelect customers and can help guide you through the refrigerator repair with useful information like difficulty of repair, length of repair, tools needed, and more.

All Instructions for the 2536480240E
256-270 of 286
Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

It would freeze up or not cool at all, depended where the clock stopped.

  • Customer: Roger from Owatonna, MN
  • Difficulty: Really Easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Screw drivers
  • 0 of 0 people found this instruction helpful
Removed the lower trim panel from front of fridg. and loosened two screws enough to turn it about 1/4 inch so the screw heads were in the larger holes. Pulled it out disconnected the wire connector and transfered the heat shield and screws to the new clock, connected the wire connector and aligned the screws. tightened them and job done. Has worked like new sense. Thanks Roger

fridge not cold stays running

  • Customer: Joseph from Deland, FL
  • Difficulty: Really Easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Nutdriver
  • 0 of 0 people found this instruction helpful
unplug fridge,Then take rack out n remove the 2 screws on the icemaker set aside,then remove 2 screws on the back panel, cut wires n splice in new part! put back the same.

Refrig would not defrost

  • Customer: Robert from Jacksonville, FL
  • Difficulty: Really Easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Nutdriver, Screw drivers
  • 0 of 0 people found this instruction helpful
Diagnosis: used wiring diagram attached to frig and determined cause could be wiring, heater element, thermostat or timer. After completely defrosting the frig (turned it off) I removed the rear cover in the freezer and looked for an obvious problem. None seen. Removed temperature select pod from the frig box and looked for obvious problems. None seen but defrost timer appeared poorly made. Repair: Since I had no practical way of checking the defrost cycle in operation, I checked probable failures on the Part Select website and saw defrost timer as most probable. I ordered the timer. Installed it. Waited a few days to make sure the frig went through a few defrost cycles then removed the freezer rear cover. There was no excessive frost buildup so I'm reasonably sure the repair was successful.

Drawer Supports Broke

  • Customer: Joan from Brooklyn, NY
  • Difficulty: Easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Screw drivers
  • 0 of 0 people found this instruction helpful
In 10 years, this is the second time these drawer supports broke and what a difference to fix. The parts came quickly, fit well and are very easy to install. The fridge is good as new and the cheese/condiment drawer is back where it belongs. Good quality and easy to do.

broken shelf bar

  • Customer: James from Dorchester, MA
  • Difficulty: Really Easy
  • Time to Complete: Less than 15 mins
  • Tools Required:
  • 0 of 0 people found this instruction helpful
removed broken bar and slipped in new bar

Refrigerator door sagged, had to push the door to close it.

  • Customer: Michael Jude from Saint Martinville, LA
  • Difficulty: Really Easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Nutdriver
  • 0 of 0 people found this instruction helpful
Used wood blocks to raise the door off the lower hinge bracket then unscrewed the suspect hinge. Cut a small shim, two layers of soda can, to place under the lower edge of the new hinge bracket and doubled the washers by using the old one to ensure I had adequate clearance for the door. After a little silicone lube I installed the new hinge bracket. All better now.

Freezer and main compartment had wide temperature variations

  • Customer: Joseph from Tullahoma, TN
  • Difficulty: Really Easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Screw drivers
  • 0 of 0 people found this instruction helpful
I first thought the defroster heater broke - took the back wall of the freezer off and cooling fins were fine. Then took the defroster timer out and opened it up. The contacts were badly burnt so the compressor and fan ran during only part of the cooling cycle. Replacing the timer took less than 5 minutes - turn off the power, remove one screw to take out the control box, cut the ground wire (new timer housing is plastic and does not have a ground connection), remove two screws to unmount the timer, unplug the old timer, plug in the new timer, fasten with two screws, put the control unit in and fasten with one screw, turn power back on.

I broke the Meat Pan while washing it

  • Customer: Barry from Allentown, PA
  • Difficulty: Really Easy
  • Time to Complete: Less than 15 mins
  • Tools Required:
  • 0 of 0 people found this instruction helpful
I ordered the replacement part on-line. When I received the part, I realized it was the wrong part. I contacted PartSelect and worked with the service representative, Julie H. She was excellent!! She determined that I had used an incorrect model number, and then she directed me to where I could find the correct number. She gave me clear directions on how to return the incorrect piece, and then sent me a UPS label to cover the shipping costs. Julie H was at all times, professional, friendly and very helpful!! Regards, Barry Halper

Door Shelf Retainer bar cracked

  • Customer: Francis from Buffalo, NY
  • Difficulty: Really Easy
  • Time to Complete: Less than 15 mins
  • Tools Required:
  • 0 of 0 people found this instruction helpful
I just snapped the old one off , and then I snapped the new one on. Simple!

Water Leaking From Ceiling Of Refrigator

  • Customer: carol from bay shore, NY
  • Difficulty: Really Easy
  • Time to Complete: 30 - 60 mins
  • Tools Required: Nutdriver, Screw drivers
  • 0 of 0 people found this instruction helpful
I ordered a new door gasket and defrost timer ,which this site recommended. The parts came in two days time (y) excellent !! I watched the video for the timer on the parts list and the replacement was so easy. By the way im a woman lol ,anyone can do this and the new gasket took like 5 mins . Im keeping my fingers crossed this eliminates my top glass flood problem. This site is wonderful thank you carol

Missing refrigerator shelf and freezer shelf

  • Customer: Rose M from West Chester, PA
  • Difficulty: Really Easy
  • Time to Complete: 15 - 30 mins
  • Tools Required:
  • 0 of 0 people found this instruction helpful
I was so surprised that the shelves that I ordered arrived the very next day after I placed my order. It is an old Frigidare in one of our rental units. When the students moved out, the shelves were missing. My husband had no trouble assembling the shelf for the fridge and replacing the one in the freezer. But I was especially happy with the time frame for delivery. Thanks.

Refrigerator Ran Constantly, Was not Cooling as well.

  • Customer: Mark from Hertford, NC
  • Difficulty: Really Easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Nutdriver, Screw drivers
  • 0 of 0 people found this instruction helpful
Looked up troubleshooting info on your web site. Decided to replace the defrost timer. Ordered it using Paypal. Received the Shipment in about 1.5 days in Rural NC. Watched Your Video, cut off power to the fridge, removed the top self and unbolted the panel, removed the defective defrost timer, installed the new one and re-installed the panel and top shelf. Set the timer to defrost to check the operation (looked inside the freezer to see that the defroster was glowing red - it was) waited about twenty minutes to ensure that the fridge started cooling again. Fixed!

shattered bottom shelf (crisper shelf)

  • Customer: WENDY from MONTROSE, CO
  • Difficulty: Really Easy
  • Time to Complete: Less than 15 mins
  • Tools Required:
  • 0 of 0 people found this instruction helpful
Simple drop-in. No tools. Less than one minute "repair" time. Worrying that the glass would break en route was for not; huge box with lots of peanuts and bubble wrap prevented any potential breakage. Very satisfied with price, shipment (including time), and overall "repair".

Freezer dripped water and items thawed but compressor ran.

  • Customer: James from Montross, VA
  • Difficulty: Really Easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Screw drivers
  • 0 of 0 people found this instruction helpful
Instructions from partselect were very clear and probable cause made it easy to narrow things down. I have the manual for the refrigerator that shows the location of the defrost timer. Very surprised that it turned out to be a cheap and easy fix.

Door Shelf Retainer Bar Was Broken

  • Customer: Vicki from St. Augustine, FL
  • Difficulty: Really Easy
  • Time to Complete: Less than 15 mins
  • Tools Required:
  • 0 of 0 people found this instruction helpful
I just snapped-on the bar to the refrigerator door. It took less than 30 seconds and the repair was complete! I am so happy!
All Instructions for the 2536480240E
256-270 of 286