22RA-4 Magic Chef Range - Instructions

Pulled knob,removed 2 screws removed wire,removed old ignitor repl. With new reversed procedure,done

This item had to be returned. Didn"t fit. Our shaft is shorter, and the new knob would not stay on.

Purchased a 1999 RV discovered the oven was misssing a rack and we were unable to use.
Located the part, ordering was easy. The rack arrived and fits perfect in the oven like it was made for it.

Thanks

Removed igniter wire, 2 screws, removed old igniter and reversed procedure, checked spark
and then lit burner. Easy, Easy

Make sure that gas is turned offf to appliance.I had to remove the top of the range and use adjustable wrench to loosen the two gas tubes. Then use screww driver to remove valve from gas feed tube ( oh - make sure to turn of gas at apppliance gas valve). I then had to use the adjustable wrnech for removing the flange.

Caution should be used when reinstalling the tubing. Also test all jionts with soapy water.

This is a small RV cooktop. There is no pilot light but each burner will light using the spark type ingitor twist knob. Raise the front of the stove cooktop. It is on a hinge. Replace the ignitor assembly using existing screws. There is a very small anchor pin on the ignitor assy. which protrudes 1/16" from the base. The anchor pin hole had not been drilled into the stove face plate which prevents the ignitor assembly from twisting when engaged. So I drilled a 3/16 anchor pin hole exactly where required. It is important to be exact so as to align the installation screw holes in the face plate. These holes can be enlarged if need be however. Align the pin with the anchor hole and install the 2 existing screws. Attach the ignitor lead to the ignitor assy. and install the new knob. Close the stove top and start cooking.

1. Unscrewed glass cover on bulb
2. Removed old bulb
3. Screwed in new bulb
4. Replaced glass cover
5. Mixed drink & baked cupcakes

The hardest part was taking out original light bulb because screws on shield where hard to unscrew after all this years . The old bulb vent out leaving neck in socket. It took narrow electrical pliers to get neck out .The generic appliance bulb did not fit and had aluminum neck ,not recommended for brass sockets in ovens.Putting new light bulb in was not the problem.

My husband took the plastic cover off and took out old bulb and screwed in the new one. Then put the cover back on.

I removed the igniter cable from the old knob. Removed 2 screws and the old knob, installed the new knob with 2 screws and plugged in the igniter cable. Works like a CHAMP!!! Must be an Oklahoma State University Football igniter and knob!! 2001 Big 12 Champions!!!!!

I pulled down the wire around the glass cover. . . Released on end of the wire from its holder being careful to not let the glass cover drop. Unscrewed the bulb and replaced with replacement. Easy, easy.

very easy

Screwed in light bulb and glass protector

The igniter on our RV stove top failed after 4 years of operation. The repair took about 8 minutes and everything works fine.

remove and replace