1CWTW4840YW0 Whirlpool Washer - Instructions

took broken agitator dogs out and put new parts in, it was very easy repair.

remove top cap on agitator, remove seal from inside of agitator tube( seal looks like garbage disposer stopper)now you see top of bolt head, use 7/16 socket with a 12 inch extension, hold bottom of agitator to keep it from turning while removing bolt,pull up on agitator top to remove, remove assembly that holds the cog's,slide off retainer ring, replace with new cog's, (when reassembling match pins in bottom part of agitator to slots in top part of agitator.)install bolt, install seal(use some laundry detergent so it slides in easily),put cap of agitator back on. that's it

Took the back of the control panel off, lifted the top of the washing machine up took off nuts holding the latch lock off, installed the new parts put back together. Piece of cake...because i got the right parts the first time. Thank you PartSelect.

took top agitator off, cleaned it (needed anyway), replaced agitator directional cogs, replaced washer (old one was too soft to reseal) upon bolting back together. Oddly the repair kit on this website does not include a washer - I only bought the cogs - it turned out to use the same washer I use on my kegerator

Very easy repair less than 15 min. to complete. The ordering was very easy, and quick shipping. Glad to see parts made in the USA.

I had to pry cap off top of agitator. Using a 9/16 socket a 4" extension 3/8" rachet. I loosened the nut holding the top of agitator to the bottom. The reached into the opening and slide the cog holder out. Removed the reainer ring and slide the cogs out. Installation is the reverse. total time less than 15 mins. My agitator is now agitating. Thanks

$3 part and 15 minutes and the problem is fixed.

with socket and rachet with adapter took me like one min. to take off part about one min. to take it apart to get to cogs. and about two mins. to put back together. i say it took 15 to 30 mins. because while parts were off and apart i cleaned them all before putting back together. can't beleive such little parts caused so much trouble. machine runs like new now. thank you

pulled lid off[fabric softner already removed], removed 7/16 bolt, pulled up, removed dogs, replaced with new, reassembled,and WIFE HAPPY!!!

Found a video showing repair steps on YouTube. Removed agitator cap, seal and retaining nut. Replaced old cogs and reassembled.

Pull top cap off, removed inner disk, used 7/16 socket to remove bolt and replaced cogs. Thanks for instructions online. Ken

Just follow the partselect video connected to the part! I have tracked down some appliance parts locally in the past but I must say that using partselect was so much easier and educational than driving across town and/or making calls. For $10, the 10yr old washer is back and operational as it should be. It's only about a 15 minute job but after reading other comments here, I went ahead and cleaned the scum(yes you have it too) on the inside of both the bottom and top agitator pieces. If I need appliance parts, I will be back to partselect. Ordered Sun at 930p and got part Tue at 10a. Great Job! Great Service! Good to see it still exists out there.

watched video on facebook, and followed the instructions,one of the easies repairs I have had to do in a long time.

removed the aggitater and the replaced coggs, no difficulties at all ,thanx for the very quick parts delivery

I watched your'e easy to do repair video and it was so easy. I just followed the instructions and it saved me an expensive service call as we live in a rural area. Thank you so much.