Models > 14788B0

14788B0 General Electric - Overview

Get Parts and Repair Help for 14788B0

If you know the repair part you need, you can browse the list of all parts on the 14788B0, or you can search by name or part description. You can also find your part by where it is located on the 14788B0 by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your . We’ve also included any installation videos we have for 14788B0 parts. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

Search for parts
Keep searches simple, eg. "belt" or "pump". Need help?
$69.05

Round Style Oven Igniter

Be very careful when handling this igniter as it is very fragile. This igniter has a range of 2.5 to 3.0 amps. Please note - this will not replace the flat style igniters. Also kn...

$89.55

Oven Sensor

This sensor detects the temperature within the oven cavity.

$29.82

Hinge with Roller - Right Side

$34.18

Hinge with Roller - Left Side

$16.87

Broiler Pan - Large

Includes the pan and grate.

$2.36

Single Screw Only

Sold Individually.

$26.48

Double Drip Pan

This double drip pan can be used for either the left or right hand side of the stove top.

$2.79

Screw

Sold Individually.

$2.36

Light Lens Gasket

$2.79

SCREW-10AB

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

broiler works, bake oven does not work.

  • Customer: Robert from Hebron CT
  • Difficulty: Easy
  • Time to Complete: 30 - 60 mins
  • Tools Required: Pliers, Screw drivers, Socket set, Wrench set
  • 423 of 516 people found this instruction helpful
Your website help me troubleshoot the problem and locate the part. Part was delivered the next day. Following the instructions that others on your website had provided, the repair was quick and SUCCESSFUL.
Gas will not flow if the igniter is bad. Gas will only flow if the igniter heats up the internal bimetal strip which in turn, allows gas to flow t... read more

Oven igniter failed to heat up and ignite the gas burner.

  • Customer: Paul from Santa Rosa CA
  • Difficulty: Easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Socket set
  • 218 of 294 people found this instruction helpful
Before starting it's a good idea to disconnect the electricity and turn the gas valve off behind the stove.

Next, uncrew the two finger-screws at the back of the oven that hold the porcelain & steel drip plate in. It comes out if you push it towards the back of the oven and lift it out. This reveals the burner and the cylindrical igniter attac... read more

Oven tempature was approximately 150 degrees to low

  • Customer: James from Austin TX
  • Difficulty: Easy
  • Time to Complete: 1- 2 hours
  • Tools Required: Nutdriver, Screw drivers
  • 131 of 154 people found this instruction helpful
This repair is EASY if you know how to use an ohm meter. If not, seek help for this step.

SYMPTOM:
The oven (JKP27WOP3WG or JKP27WP3WG and many ovens like it ) was not getting hot enough. Verifying the cooking temperature with an typical oven thermometer, I was able to determine that the oven was cooking temperature was about 150 degrees t... read more