11098762790 Kenmore Washer Dryer Combo - Parts

Drum Support Shaft - Rear Shaft with Right Hand Threads

★★★★★

★★★★★

(2)

Shaft for dryer drum support roller. Rear shaft with left hand threads. Part is updated so nuts may need to be replaced as well on older dryers. Add to cart

Drive Block - 2 5/16 Inch High

★★★★★

★★★★★

(2)

This part is for large capacity belt drive and direct drive appliances. Add to cart

Water Inlet Syphon

★★★★★

★★★★★

(6)

This part prevents water from flowing back into your main water supply line. Add to cart

Lid Switch Kit

★★★★★

★★★★★

(10)

The point of the lid switch is for the tub to stop spinning when the washer lid is opened. Add to cart

Lid Bumper

★★★★★

★★★★★

(4)

This gray and white washer lid bumper contains a rubber bottom and is sold individually. Add to cart

Clutch Lining Kit

★★★★★

★★★★★

(3)

This kit comes with springs, hardware, and brake lining. Add to cart

Spring Outer Bracket

★★★★★

★★★★★

(1)

Sold individually. Add to cart

Drain Hose with Clamp

★★★★★

★★★★★

(2)

Used to drain water. Add to cart

Drum Support Roller Shaft - Right Hand Threads

★★★★★

★★★★★

(1)

This front shaft with right hand threads is used in dryers. The shaft and the drum support rollers ride on to support the drum. If your shaft has flat spots and the rollers do not spin, replacing the ... Add to cart

Inlet Hose - 5 FT

★★★★★

★★★★★

(3)

This hose can handle hot or cold water and is five feet long. Add to cart

Leveling Leg Locking Nut The leveling leg locking nut is an OEM replacement fastener for use in dryers and washers. It has a head diameter of 3/8 inches and a thread pitch of 16 threads per inch. The nut secures the leveling ... Add to cart

Screw, 8-18 x 1/2 This screw is sold individually. Add to cart