1106807704 Kenmore Dryer - Instructions

Watched Youtube video first then followed directions included with belt. Very simple and easy to follow.

I just remove two screws slip the old off and slip the new one on replace the two screws back put top of dry back in place replace two screws from dry lint trap

I watched a youtube video about how to replace a dryer belt. I did what it said.

Followed the On Line Repair on my Lap Top. Very Easy !

Followed instuctions on video accept our appliance was the Duet HT model so we had a glass window to deal with. Just a few more screws to keep track of but otherwise a very easy repair.

Thanks to your video my husband felt very confident and the belt was installed with no problems.

ordered new latch. Arrived promptly. Installed in 5 minutes. Actually easied than the video. Thanks

The Door Catch Kit had clear instructions for installation and included multiple replacement catches to fit several different sizes/varieties of dryers. I used a screwdriver to pry out the broken door catch, popped in the replacement, and was done! As usual, PartSelect had what I needed at a good price, with clear instructions for any needed installation. Fast shipping, too.

I was very pleased with the shipping speed, the belt arrived in less than 24 hours! The installation was very easy and if you need help the video on the belt info page should be helpful.

Took the old one out and replaced it with the new one.

I had to take the top loose and raise it up. There are two screws in exhaust vent you have to take out then you can raise the top. When you raise the top you will have to take the front loose and open it up enough to take the drum out. Go to the back and take the lower cover off and take the screws holding the exhaust vent out so the vent will come out the top. When you take the vent out you will see a fan on the end of the motor shaft. The fan is threaded on the shaft and it is left handed threads. As you face the fan you will have to turn the fan to the right to get if off. You will need someone to hold a back up on the motor shaft inside the dryer to keep it from turning. Take the motor out then get the new motor and wire it according to instructions. Install the motor on the motor mount, put fan on then put everything back in reverse order that you took it apart. The hardest part for me was putting the clips on the motor when I put it back together. Hope this helps you.

Had to guess at replacement (dryer too old to still be listed) picture and measurements looked right; it was, Old one out--new one slid in, great that it was available.

You pop the top of the dryer. Remove to hex screws which allow you to remove the front panel. Next you pull the drum off, snack the belt around the drum, motor and tension pulley and reverse the steps. The hardest part is getting the drum back in place without knocking the belt off the motor.

Unplugged dryer. Removed lint tray screws. Opened top of dryer and removed the two face screws then removed front of dryer. Released the belt tensioner. Then removed the drum. Disconnected the wiring clip and with a creseant wrench held the back of motor and turned the nut in the front clockwise to loosen the motor from the vent fan. Then simply pulled the old motor out and reversed the steps and now have a great working old dryer again.

Received the part the day after ordering. Appreciated the quick service and repair took less than a minute.