1106517744 Kenmore Dryer - Instructions

Having read the instructions and watched the tape, I pried out the remaining catch with a flat screwdriver, read about what the color scheme on the parts wasbout and pushed in the correct part. Voila ! Done in probably two minutes.(By an 82 year old woman!)

The dryer belt was delivered promply, afterwards I lifted the top of the dryer and unscrewed the front panel, so it would lower. Then I watch a 5 minute video and it clearly demonstrated how to install the belt. This was my first time, so it took about 30 minutes.

changed fuse,radiant flame sensor. no help. bought a new dryer. i don't think the gas valuve was opening.everything seemed to be working properly,just no gas.

PartSelect sent the exact right part, and very quickly! YouTube showed me how to install it. The only hard part was the bulkiness of the drum, which is why I marked "a bit difficult" for the repair.

Got online with parts select, easily found the parts needed and ordered them. They arrived very quickly. The repair itself took all of 5 minutes and now the dryer door stays shut like it is supposed to. Only complaint is shipping was more than the parts but then again, I didn't waste a lot of time running all over town looking for what I needed. So, in the long run I saved money , especially when compared to a calling someone else to fix it.(big bucks for even the most minor service call as you all know).

pop off put in done

Idler Pulley wheel is broken. it really ez to repair

following the repair video made it super easy. thanks!

Followed troubleshooting steps. Checked thermal fuse (shorted)- OK. Checked igniter (about 70 ohms) - OK. checked flame sensor - (open) BAD (should read shorted). This part is normally shorted then opens when the igniter gets hot causing it to open and thus turns on the gas flow. An open flame sensor does not permit the igniter to turn on.

the video was very helpful

Watched how-to video provided on PartSelect website. Most time was spent cleaning out the cabinet of lint and other debris. I found over 5 bucks in loose change! I Found pulling the belt over the motor pulley to be the trickiest. Note: my dryer will be 30 years old come this September. I wonder how many more years I'll get out of it!

Replaced actuator switch lever. Exact replacement. Worked like a charm.

I consulted the internet and found Part Select and use online repairman to diagnose the problem and found the roller solution with the parts, video and parts illustration. Sure enough, the left roller hole was worn and egg shaped. I ordered the parts on a Wednesday afternoon. While I waited, I got all the lint from the bottom pan, motor, and around the burner cleaned out and ready for the new parts. The parts arrived Friday morning and I installed them and put the dryer back together before noon. The dryer works and sounds like a new machine. Now I am ready to attack the squeaky fan motor in the freezer compartment of our refrig.

video describing repair very helpful. just folling it made the repair easy

Located broken front door safety switch actuator. Ordered new part shown on the diagram. Removed broken part, installed new part, start dryer,runs fine.