11062066100 Kenmore Dryer - Instructions

Pretty straight forward, only hard part was getting the housing for the heating element out. After that it was plug and play. Added benefit was cleaning out the inside and dryer vent while I was in there.

Got online with parts select, easily found the parts needed and ordered them. They arrived very quickly. The repair itself took all of 5 minutes and now the dryer door stays shut like it is supposed to. Only complaint is shipping was more than the parts but then again, I didn't waste a lot of time running all over town looking for what I needed. So, in the long run I saved money , especially when compared to a calling someone else to fix it.(big bucks for even the most minor service call as you all know).

My husband changed the idler pulley. It took him 5 min. Thank you sooooooooooo much. Saved us 1000.00 dollars. He wanted to by a new one but investigated the problem on line. He is a handyman and was just being lazy. I ordered the part and he fixed it. I love saving money!!!!!!!!!!!!! And I love my husband!!!!!!!!!!!!!!

pop off put in done

Opened up unit and followed tech directions on inside pocket to isolate the problem to the heating element. Pulled it out and sure enough it was broken in one place. Found the part on PartSelect and ordered it on Saturday, received it on Wednesday. Replaced the new heating element into the assembly, reinstalled the assembly and connected the wires. Works like new now!

following the repair video made it super easy. thanks!

My dryer element was not heating and there did not appear to be any damage to the element itself. There were several thermal fuses attached to the heating element enclosure. Test them with a voltmeter and see if there is conductivity. If there isn't, then the fuse is faulty/broken. Replaced my broken fuse with 3390915 and the element heats once again. The original part was not the 3390915, but Kenmore recommends replacing the stock thermal fuses with 3390915. Thank you!

Replaced actuator switch lever. Exact replacement. Worked like a charm.

Located broken front door safety switch actuator. Ordered new part shown on the diagram. Removed broken part, installed new part, start dryer,runs fine.

We thought it wiras the heating element and we ordered that part from.you but it did not fix the dryer. So we ordered the thermal kit and little less then 15 min. we had it fixed.

Order one new latch, receive 2 spares. Pushed new latch in, re oriented the catch. was done in less than 5 min

Removed front lower panel as shown in how to do video, removed two screws from heating element bracket and pulled the whole tube that holds heating element and thermo cut off and thermostat. Used OHM meter to check out heating element, thermal cut out and thermostat. Thermal cut out was the only thing bad but replaced both thermostats as recommended. The most time was taken cleaning out cabinet as it had eleven years of lint and very lucky it never caught on fire over the years. Put all back together and dryer now dries clothes in half the time as before.

Followed the directions from your vidio,it was a snap.You Guys are the greatest!!!

I was impressed with the fast time the part was delivered. The price was good too. The installation video and instructions did not match my dryer but it was helpful to some extent. The video and instructions being different was not ya'll's fault because of the age of the dryer. It took me so long to change the switch was because of the location and design of the switch. I got it though.

My husband changed the part but part select was very helpful. With their free repair help site it made repairing a breeze! We will use parts select again and again. I did order all the parts we might have needed and only needed one. Now I will return the others.