Models > 11062054100 > Instructions

11062054100 Kenmore Dryer - Instructions

All installation instructions for 11062054100 parts

These instructions have been submitted by other PartSelect customers and can help guide you through the dryer repair with useful information like difficulty of repair, length of repair, tools needed, and more.

All Instructions for the 11062054100
391-394 of 394
Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

dryer would not run

  • Customer: paul from MOUNT CLARE WV
  • Difficulty: A Bit Difficult
  • Time to Complete: 1- 2 hours
  • Tools Required: Nutdriver, Screw drivers, Socket set
  • 0 of 0 people found this instruction helpful
After disassembling, I orderedparts.was told it could be the thermal fuse.found that the belt was broken.disassembly was simply removing screws, but as a novice, it was difficult to determine what to remove and how to remove only what was needed.after watching your video, it was much easier.replaced thermal fuse and belt.made sure to clean lint from motor and interior of dryer as well as vent lines and vent blower.the old machine works fine, until something else goes.

Door Switch Actuator Spring/Lever & Door Catch Replacement

  • Customer: Charles from Marysvile WA
  • Difficulty: Really easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Nutdriver, Screw drivers
  • 0 of 0 people found this instruction helpful
Open the top and replaced the switch bracket with the actuator lever then inserted new door catch.

Dryer runs but no hot air

  • Customer: Larry from Newnan GA
  • Difficulty: A Bit Difficult
  • Time to Complete: 15 - 30 mins
  • Tools Required: Nutdriver, Pliers, Socket set
  • 0 of 0 people found this instruction helpful
Disconnected power from dryer (safety first)! Removed bottom front panel (two screws hold it in place). Then remove the two screws that hold the sheet-metal bracket/guard in place in front of the heating element. Disconnect the two wires from the heating element terminal (white stripe wire is on top, remember for re-install purposes). Remove screw that holds heating element in place. Remove heating element from the vent housing. NOTE: The old heating element will be difficult to remove, it's a tight fit AND there's a spring on its' side that holds it tightly in place...beware that the edges are sharp; I used a pair of pliers to pull the element out in order to protect my hands. Once the old element is out, put the new one back in its' place...again watch out the edges are sharp and the element fits tightly into the vent, so if you have mechanics gloves now's the time to put them on to protect your hands, as the edges of the vent and element are sharp. Once the element is into place, secure into place with screw on left side, re-attach wires (white stripe on top terminal), put the guard back into place, close up the bottom panel, and power up.

did not dry ths cloths

  • Customer: karl from grand rapids MN
  • Difficulty: Easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Nutdriver, Screw drivers, Socket set
  • 0 of 0 people found this instruction helpful
removed front lower panel and removed 2 hex screws 1/4" on front of heater tube support unplugged 2 wires hooked to heating element and 1 hex screw on side of tube that secures element and pulled the element out with pliers it comes out a little hard and then slid new element in and put it back together easy fix
All Instructions for the 11062054100
391-394 of 394