11060012002 Kenmore Dryer - Instructions

Watched the tutorial online. Took the back off- replaced the fuse. Put the back on . It was extremely easy !!

turned off circuit breaker to dryer. pulled out from wall and turned.had to remove vent tube to facilitate moving the unit.took off back panel with socket.popped connecting wires off old hi-limit thermostat. took off old hi-limit thermostat, put on new one.reattached connecting wires.(they clip in and out.) screwed back panel on.turned unit back into position, popping vent tube back into unit.flipped circuit breaker back on.IT WORKED! didn't need to replace thermal cut-off, that was still working, but came in a kit with the thermostat.the worst part was diagnosing the problem and figuring out how to use the multi-function meter i had on hand.such a good feeling to fix it yourself and pretty inexpensively!part arrived 2 days after ordered!helpful to have 2 people to move dryer,hold pieces,hold back panel in place when reattaching.but could be done by one person.

The online vidio was very helpfull

Replace the switch in diagram #4.

unplug,disconect vent, remove the back, use the ohm meter test the thermal cut-off , test the heating element, test heat limit switch. ( that now comes as part of the cut off kit ) I tested the cycling thermostat but did not know the values so i ordered it as well. Did not need it after compairing the old to the new. every thing should show compleat circut except the cycling thermo's two center contact that should be around 8000 ohm. very easy repair and recieved the parts in two days. Watch the video.

replacer upper heat themo

Unplugged the power cord. Removed two screws on lint vent , used putty knife to release clips to raise top at front of unit. Disconnected the plug from front door switch. Laid dryer on its back. Removed two screws to remove front including the door. Vacuumed lint from inside unit. Installed belt temporarily using two pieces of masking tape to hold it in place while properly routing the belt. Gave the tub a full turn to insure alignment.. Reinstalled the front of unit with the two screws. Righted the unit and snapped down the top. Replaced the two lint vent screws. Plugged it back in and done! Piece of cake!

Once I watched a YouTube video showing me how to do the job I ordered the part from you. Am so impressed with your fast shipping and best prices via the Internet. Thank you SO much! The water level switch was easy to install, it ws getting the cover on the washer back on that was hard for me since I am 68 yrs old and have a bad knee. Its why it took me two hours to do what most people could do in 20 minutes.

I unplugged the dyer remove the back and took out the part and replaced it with the new one done !Thanks to your video I watch on the enternet.thank you so much

When the part came in. I unplugged the dryer. Pulled it away from the wall and took the back off. I pulled the wires off the old fuse and plugged them in the new fuse, then unscrewed the on nut that held the old fuse. Then slid the new one in and put the nut back on. Plugged the dryer in and it worked. So I unplugged the dryer and put the back on.

Followed procedures in Parts Select web site video

Removed the back panel, found the fuse and replaced it. Easiest thing I've ever done! I was expecting it not to be the problem, but I started with the "most common" issue via the website. Voila...it was the problem!

little more than vedio showed has a see thru door had to tke door off machine then was easy replacement and re install

Unlike your video, with this model, the thermal fuse is located near the front of the dryer, which I didn't find out until the back was already off.

I watched the online video first, which made the removal and installation fast and easy.