Quick Question!

Have you ever purchased from PartSelect.com before?

Models > 11045872400 > Parts

11045872400 Kenmore Washer - Parts

All parts for the Kenmore Washer 11045872400

Below is a list of all parts for the Kenmore Washer 11045872400. To find the repair part you need, you can browse the list below or you can narrow your choices by searching for a part by name or description.

All Parts for the 11045872400
1-14 of 162
Search for parts
Keep searches simple, eg. "belt" or "pump". Need help?
$110.36

Bellow

This part is also called the Door Boot Seal. It's the main seal between the front bulkhead and the outer tub. Clamps are not included. NOTE: Must order clamps separately, if neede

$26.99

Baffle, Basket

This part moves the clothes around inside your dryer/washer and helps to direct the flow of hot air during the drying cycle. Sold individually.

$78.98

Door Lock Latch

This part is used on front load washers and includes the interlock switch assembly.

$157.24

Drain Pump Kit

This pump helps expel water from the washing machine and is activated after the spin speed is maintained for a specific period of time. This part is used on front load models.

$58.26

Water Inlet Valve

Used with some front load washers. The attaching solenoids on the valve open and close according to the desired temperature, or amount of water needed.

$40.29

Shock Absorber

Shock absorbers help keep the washer from vigorous shaking during its cycles. Sold individually.

$19.50

Bellow to Outer Tub Clamp

Used to help hold your bellow in place on your washer.

$41.76

Flowmeter

This part continually measures the amount of water entering the tub. It will make adjustments if too much or too little water is present.

$6.92

Door Hook/Strike

Attaches to door lock mechanism.

$3.02

Screw with Washer

This metallic screw is less than an inch long and comes with a plastic washer.

$30.65

Drive Belt

This drive belt is made to slip on the motor pulley to bring the basket up to the speed required and this makes the belt get wear and tear. NOTE: Per Manufacture, belt measures 48...

$22.61

Pump Hose

This hose attaches to water pump assembly. NOTE: As per the manufacture if the washer has an Eco Ball, it's no longer needed when the new hose is installed.

$8.45

Foot, Leveling

Sold Individually.

$5.51

Hose Clamp

The hose clamp is used to hold the water hose in place which will prevent the hose from leaking water. Sometimes the clamp may lose its ability to latch on, causing a leaking washer. For the installation, you will need a flat head screw driver to replace the clamp and a drill to access the screws to remove the front of the washer. Be careful if you do not have specific clamp pliers as the clamp could fly off. Once the front of the washer has been removed, take a quick look for water damage or any obvious signs of where the leak is coming from. If it is not obvious, run water to test.

All Parts for the 11045872400
1-14 of 162