11026912691 Kenmore Washer - Instructions

took off front cabinet removed pump,and then motor and replaced part.

Popped the top of the Agitator off by hand, removed the softener cap protecting the Retaining nut by hand and used a 3/8 in socket driver with an extension and a 7/16 in socket to remove the retaining nut. Pulled top of Agitator off shaft, flipped it over and removed the Dog Ear housing. Removed retaining ring, removed and replaced Dog Ears (Cogs) and reassembled...less than 15 minute fix!

Unplugged washing machine and tilted washer back toward wall. Loosened clamps,removed hoses from water pump and drained water into shallow basin. Pried retaining clips up with screwdriver and lifted pump off of motor shaft. Installed new pump on motor shaft and secured pump with retaining clips. Re-attached hoses and secured clamps. Returned washer to upright position, plugged washer in and ran it through a test cycle with no problems. Watched the video on the replacement of the water pump, so the process was very simple.

Washer started leaking so I carried it out on the back deck so I could still use it until I had time to fix it, ordered pump, it came in about two days, took about ten minuets to fix and put back in the laundry room. I've had this washer and dryer set for nearly twenty years, I do most things myself, ordering online and having the parts waiting on me when I get home makes things so much easier

Followed partsselect video repair guide... it went super.

7/16 socket you need 8inch extension to reach one bolt.every thing else donot need tools to get to the bolt eazy

Shut off water and unhooked lines. Pulled machine out,turned on back to access pump/hoses, noticed crack in pump. Ordered new part which arrived in two business days.Replaced pump which took 10 minutes,hooked washer back up and ran a test load of towels. Perfect.

Last time the washer had this problem, it was the lid switch. Jumped the connector to make sure that was the problem. Ordered new switch. Followed the directions on-line, but did not understand which screw to take out of the back panel of the washing machine. Turns out, did not need that step. Must have a different model than the one used in the demo. Everything else worked exactly like the repair demo.

This was an easy repair. I used a 7/16th socket on a 8 inch extension to reach the agitator bolt. After removing the bolt, I pulled off the top half of the agitator, leaving the bottom half intact and attached to the washer. After that it was a simple replacement of the agitator directional clutch dogs and then putting the top half of the agitator back in place and tightening the bolt.

thanks for the part, it worked!

Watched the video and it was very straight forward, very easy and time saving. I just wish the delivery time for the part was that fast (It was a quick delivery).

Disconnected water and power supply. Turned washer face up and removed pump. Easy to install just 2 hold down clips.

Removed washer cabinet. Unclipped pump and disconnected hoses. Put hoses on new pump. Attached pump to drive unit and reinstalled cabinet.

It was a no-brainer repair. We removed the worn hose and replaced it with the new one. Only variable was that the new clamp was too big for our fitting, so we used the old one. The clamp was the only mechanical thing we did. The best part was the very prompt delivery of the new part and the help finding it from the rep at the company.

repair went well. video presentation was helpful but our washer was not quite the same as video. we had to print the assembly diagram to visualize the proper order to place the new parts. all in all it was a simple fix.