10652284200 Kenmore Refrigerator - Instructions

First I read your trouble shooting guide and determanded it was the ice maker. Then I watched your repair video which was very helpfull. I ordered the new icemaker, When it arrived I installed per video using only a 1/4 inch nut driver. IT was esay. New ice maker works great.Thank You for the information you have online and the parts and service.

Moved the refrigerator out, unscrewed old fill tube, pulled it out, placed finger-screw on water line, screwed it on, put in new fill tube, re-screwed fill tube in place, put refrigerator back into place. Done!

Removed the six screws holding the bottom access plate found at the rear of the refrigerator. This gives you easy access to the run capacitor that has a retaining clip. Remove the wire clip and pull out the capacitor (it has two quick disconnect terminals). Reverse the process using the new run capacitor to complete the repair.

Easy.... Video made replacment very smooth. I only needed one tool a nuy driver.

I saw a video of it, and simply took apart the ice maker and put the new Auger Drum in, then reassembled the ice maker.

The repair was easy. I wish I would have had a nutdriver; that would have made it extremely easy and a lot faster. I used a small wrench to take out the old ice maker. The new one went in easy. The arm was easy to move from the old ice maker to the new one, but it was a bit snug. We had to manually push the arm down a few times for the icemaker to dump the ice. After about 5 batches or so, it began to work on its own and now we have a full tub of ice (for the first time in two years). This was certainly time and money well-spent. Any one can do it!