10650502991 Kenmore Refrigerator - Instructions

The customer service people did some cross checking and found a shelf and drawer that would work in my fridge. It did!! I love it now!!!Thanks for your help I did have to remove one of the selves - but now I have an extra!

I followed the video and was done with the replacement in less than 20 minutes. Just make sure after turning the water back on you check for leaks before you move the refrigerator back.

Previous to installing the new ice maker - I replaced the dual inlet water valve per the instruction video I found @ partselect website. That did not solve the problem <> I also adjusted the timer on the old ice maker down - per another video / which also did not solve the problem. Then I viewed the video on icemaker replacement - ordered the ice maker & 3 days and 15 minutes later <> the problem was fixed ! This web site is "fantastic" ! Thankyou partselect for your assistance ! ! !

Just slipped the shelf in the door

Package came in two days.I opened the box ,took the old draw out and slid the new draw in. Fixed in less than two minutes.I would definitely order from Parts Select again. Thanks for the prompt service

Watched the video provided, then followed that procedure. Everything now works fine, no more clicking.

Took ice maker out all together we removed 4 to 5 screws had to remove axel to get the broken piece out and new one in my husband said it was easy in and out in about 15 minutes saved about 150. 00 Thanks partslect

I took out the old drawer and inserted the new drawer in the same place! I wish all of life were that easy!

Replaced the Ice Maker Control asssembly. Online video instruction were ectremely helpful. Time to repair was about 10-15 minutes and we have a funcioning ice maker again!

Removed three screws. Discount wire harness. Reverse proceedure for installation.

Watch the u-tube video first ,Then read instructions that came with new unit ! so darn easy. unplug fridge, remove ice bin, clean and dry bin before putting back in service! stick flashlight in freezer loosen 2 top screws remove 1 bottom screw, unmount unit, unplug wire harness, remove icemaker and put on table, close freezer door !! , Remove sensor arm from old unit in down position and install in new unit. plug in new unit and reattach in freezer. replace ice bin and plug in fridge, that's it!, It took about 2 hours for the icemaker thermostat to say OK lets go had a load of ice in aprox 3 hours from finish. piece of cake. Jon

Read the suggestions of possible repairs on PartSelect web site. Ordered part based on these suggestions. Part was received within two days. Followed installation instructions found on the web site. Part was installed within fifteen minutes. Ice bin was full the following morning.

Before I ordered, I followed the great video to disassemble the unit. That's when I realized I only needed to buy the drum. Five days later, I had the part. I thought I remembered how to reassemble it, but I ended up needing to watch the video again. It wasn't difficult, but you must get all the bits back in the same order!! Once that was dine, it all went together easily. Thank you! I'm so impressed with this site that I posted on Facebook about it so my friends can also save big bucks doing simple repairs themselves.

I first viewed the instructional video provided by Partselect to pin point the faulty part. It was the control bracket. I would not have known how to expose the control bracket if it weren't for the video. Also Partselect said 48% of past water dispenser problems were the control bracket; this also helped me pinpoint the faulty part. I ordered the part; it arrived in 3 days. Using the video as a guide I repaired the dispenser in about 20 minutes start to finish. I will always go to Partselect for all appliance problems.

Open fridge....empty old drawer....through out old stuff....remove broken drawer and take downstairs to trash bin. Remove new drawer from package....open fridge. Insert new drawer. Restock with remaining items. Have a cold drink and congratulate yourself for a job well done!!!