10645433800 Kenmore Refrigerator - Instructions

Replaced the Electronic control boards first, emitter and receiver, and that did not fix the problem. I then order the Control board/motor assembly in the ice maker, this did fix the problem and after a couple of hours I had ice. The repair was easy and the videos on the web site show you step by step.

Followed the video on Parts Select and it was a breeze.

Originally ordered parts I thought would fix ice maker. When I took apart the icemaker assembly I noticed and found the actual part that went bad. Called customer service and was able to return the parts I thought would fix the ice maker, without any problems. I ordered the correct part on the same call. Within a day or so the new part arrived and was installed within 15 minutes. Thanks to the instructions & comments posted on the "Instant Repairman" link. Awesome customer service that can not be bet.

Swapped out the emitter and receiver control boards. Super easy. Watched the video on how to do it on your website.

removed ice maker took motor assembly off the end of ice maker, and installed the new part. this was pretty easy because I have taken it apart before. But this is not a hard job for a novice.

Very easy - simply turn on the new cap.

The replacement ice maker water inlet was taller than the original. I had to disassemble both the new and old unit to replace the new water inlet with the old one. The video was very helpful in troubleshooting, removing and installing the unit.

Watcheda U-Tube type video of how to repair the unit. This was very helpful in that it identified a screw that had to be removed but was not visible upon my initial observations. Also it mentioned that you had to re-use some of the original hardware in order to complete the replacement. My only complaint is that I believe the failed motor could have been replaced for about $15 but I was not able to find that specific part in any catalog and opted to replace the entire unit. Overall I am extremely well pleased. Everything now works fine.

Followed the video. only problem old ice maker was frozen in place. Had to thaw out in order to slide old ice maker out of slot. other then that, new one is working fine.

research of company website showed parts to buy (per percentage of failure) and how to install those parts I viewed video on installation of parts and did the job, it was a snap

Went to parts select and found diagram of parts then found their page that shows percentages of each part being the cause (very helpful) then I watched video of repair (very, very helpful) and fixed the problem. Your company, PartSelect is the best! Rick

Web site is fantastic, I used web site to figure out my problem and order parts, I also used web site on how to install which made it a snap to do repair Ice maker up and running, all replacements parts were factory which fit perfectly

easy,remove old parts installed new parts,icemaker started working properly.

Followed instructions posted on your site. It was straight forward and very simple to complete.

Initial diagnosis incorrectly led me believe the problem was with the optic eye. After replacing the optic eve and still no ice, I realized the problem had to be with the actual ice maker itself. The removal of the old ice maker and installing of the new one took less than 5 minutes. This of course was after watching the repair video first. I still feel that I saved money by doing the repair myself instead calling in a appliance repair man, even with the added cost of the probable unneeded optic eye replacement. I am very satisfied.