10644102300 Kenmore Refrigerator - Instructions

Openned both doors and removed lower grille. Closed doors and placed a piece of wood underneath door. The piece of wood slightly taller so that it supports and lifts the door while I worked. Working at the bottom of the door removed both upper and lower plastic cams and replaced with new ones. Be sure to tighten the single screw that holds down the plastic cam; if you leave them loose they will split/crack because they will move as you operate the door.

Looked at drawing to see what sequence the parts went.

Trouble shot the ice maker using the read out codes. Code indicated a faulty ice maker. Ordered a new Ice maker and replaced the faulty ice maker. Only problem is the water funnel one the new ice maker is taller. This required bending the water fill tube to slide the new unit in place.

If you follow the video to the letter it's a piece of cake

remove old ice maker no fasteners and one electrical plugin and transfer plate from old ice maker and reinstall very simple. was delighted to see it arrive so soon........thanks for that

Used the instructions provided on the web site. They were very clear and easy to follow. I might add, I am an 82 year old 30 year military retiree and I am used to problem solving. Yours in service, Jimbo

The hardest part was figuring out how to get the front panel escutcheon panel off. With the putty knife under the bottom flange, you need to push down with some effort on the part of the flange where the drip pan slides in and twist the putty knife to disengage the locking tab. Once the panel is off, the rest of the job is easy with the aid of your video. Everything works like new...thanks.

I knew that if my freezer temp seemed Ok and my refrigerator was too warm that I should be looking to see if my evaporative fan was working. It blows the cold air from the freezer through to the refrigerator. Turns out that the unit was working and I figured out by viewing other customer experiences there was a diffuser door that opens and closes with a thermostat that was not operating. Replaced it and everything is fine.

I found the part I needed at parts select and followed the video on their web site. They have a very informative web site, it made my job easy. I highly recommend this company.

Top left mounted Icemaker facing front. Disconnect power to fridge. Using 1/4" nut driver remove single silver nut under right rear side. It holds a plastic cover over the electrical connection, unhook the cover and remove it. Release clips under front lip under both sides and entire icemaker will slip and twist out. Remove electrical connection to ice tray. Place assembly on bench and remove 3- 1/4 hex screws from under side to release bottom tray. Snap cover off motor and remove. Carefully align pin and arm on control assembly to ice tray and-re assemble. May take 30 min to dispense. Discard till clear.

Watch the movie adjacent to the part on the ordering list,follow said instructions you can't miss.Thanks for the movie,the ease ordering the friendly associate that took my order and your timely shipment.Once again thanks for everything.Thomas J

Removed the old outlet valve and installed the new outlet valve in less than 15 minutes. Thank You Part Select!

Repair was easy. But what I really liked was the prompt/timeliness of the correct part delivery. That's what really made the difference. (My ice bucket is FULL of ice).THANKS!!

Used 1/4 inch nut driver with swivel to remove the part retaining screw. Held new part into place and installed the retaining screw. Challenge was not hitting the level and putting water on me and the floor during installation. Relatively easy installation as long as you have patients.

Removed the refrigerator door (after taking everything out of the shelves). Took the old Lower Door Closing Cam off (it was totally worn down), installed the new one, rehung the door. Rehanging the door took a couple of tries to get it properly aligned. Very easy fix, We thought we had to replace the refrigerator since it is 14 years old, but this fixed the problem completely!