drum support roller was squeaking

ApplianceMaytag Dryer

Model

Level of DifficultyEasy

Time to do repair1- 2 hours

Age of ApplianceMore than 10 years

Tools Nutdriver
Screw drivers
Socket set

Kevin From San Diego, CA

Apr 07, 2008

2 out of 3 people found this instruction helpful

My 11 year old grandson and I did the repair together. He had a blast and I did too. First we removed a bunch of screws that got us no closer to getting the machine apart than when we started. Then I remembered from the last time I had the machine apart that there are two screws just below the door, angled as not to be visable unless you know where to look. Once we removed those the from came off. We removed the wires for the door light and heat sensor, remembering the order of the wires for later reinstallation. Then we undid the bolts holding down the top. Once the top was removed we took off the belt and removed the drum. We used the retainer pliers to remove the retainer ring from the first roller. We removed the roller and also the shaft as this roller was the noise maker and the shaft was not in reusable condition. We installed a new shaft, roller washer, roller, another roller washer and then the retainer ring. We repeated the same process on the other roller, although we did not replace the shaft as it was in good condition. It turned out I did not need to order the shaft washers as the rollers came with washers. Oh well, its not a good job unless you have parts left over when you are done. Once we replaced the rollers we commenced reinstallation. But first we had to google for diagram of the proper belt installation, which we found and that got the drum and belt installed properly. Thankd god for the internet. Once we had the drum installed we put the machine back together in the opposite order we took it apart. An operational test showed we did the job right, no more squeaking. The only injury was my grandson cut his thumb right after I gave him the speech about watching where your hand is going to end up when that bolt breaks free. It broke loose and into the metal bracket went his thumb. Oh well it was a good lesson and it was not a bad cut. All in all a good repair.

Help other customers find the most helpful instructions.

Were these instructions helpful?

Diagrams and Parts List for this repair

Part PhotoPart DescriptionPriceAvailability

Retaining Ring (Now subbed to Retaining Ring)

Part Number: PS401591

$2.70
In Stock

Drum Support Roller (Now subbed to Drum Support Roller Kit)

Part Number: PS1570070

$19.73
In Stock

Roller Shaft Washer (Now subbed to Drum Roller Shaft Washer)

Part Number: PS2031959

$2.70
In Stock

Roller Shaft Hex Nut (Now subbed to Roller Shaft Hex Nut)

Part Number: PS2035395

$2.70
In Stock

Roller Shaft (Now subbed to Roller Shaft)

Part Number: PS2347258

$5.00
In Stock