Dryer Drum wouldnt turn

ApplianceKenmore Dryer

Model417.91142000

Level of DifficultyEasy

Time to do repairMore than 2 hours

Age of Appliance5 - 10 years

Tools Screw drivers

Colby From Peyton, CO

Dec 15, 2009

0 out of 1 people found this instruction helpful

1.) Unplug Dryer
2.) pop dryer lid by depressing 2 front clips with flat head screw dryer
3.) on back of dryer remove access cover and release belt tension
4.) remove front panel screws and then pop off front panel
5.) remove old gasket. Used XACTO knife, razor blades and acetone. Go slow and be careful.
6.) apply new high temp glue, let set up for a minute
7.) position the new felt gasket and clamp into place. I used C-Clamps and squeeze clamps.
8.) I let sit overnight.
9.) re-assemble and good to go.

NOTE: In retrospect I should have replaced both seals at the same time. The bottom seal is pretty worn but is still working out for now.

Help other customers find the most helpful instructions.

Were these instructions helpful?

Diagrams and Parts List for this repair

Part PhotoPart DescriptionPriceAvailability

Upper Drum Glide

Part Number: PS470317

$18.16
In Stock