Microwave Oven Combo Fans and Blowers

Your Price

$26.60

Microwave Oven Combo Evaporator Fan Blade Kit

★★★★★

5 Reviews

PartSelect Number PS304684

Manufacturer Part Number WR60X114

This kit features a 5-blade plastic evaporator fan blade that rotates CCW and measures 4.5-inches in diameter and has a 3/8-inch-tall shaft. This kit also has a metal compression ring that secures the fan to the evaporator. The evaporator mechanism is normally located in the freezer and is responsible for pulling the warmer air over the condenser coils, cooling it off and then blowing and circulating that cooler air through the rest of the refrigerator. If the freezer compartment has a frost buildup or if there is a lack of cooling and airflow in your refrigerator, this fan likely needs to be replaced. To replace your evaporator fan, you will likely need a screwdriver and a set of pliers and check your user manual for the exact location of your evaporator fan.

Fixes these symptoms

Fridge too warm
Noisy
See more...

Installation Instructions

Keith from Fort Worth, TX

Noisey fan/motor (bad motor bearing ?)

Removed 2 phillips head screws to remove ice maker (could have just loosened them)
Pulled fan off of shaft
Removed 2 phillips head screws on motor bracket , disconnected three motor wires & removed motor.
reversed process to install new motor & fan blade.
Space was a little tight for two hand and arms, but do-able. Read more...

Videos!

Your Price

$19.43

Microwave Oven Combo Convection Fan Blade

PartSelect Number PS3409337

Manufacturer Part Number 318398302

This convection fan blade is designed for use with various makes and models of range and oven and is sold as an individual part. Made of metal and measuring approximately 4.75-inches in diameter, this genuine OEM fan blade works with the convection motor to circulate and distribute heat evenly throughout the oven. If your oven is not getting hot enough or the heat is not circulating properly, or if the fan blade in your oven has become warped, damaged, or chipped, it needs to be replaced immediately. To replace the fan blade, disconnect your range from the power and locate the fan assembly. With the appropriate screwdriver and wrench, remove any assembly covers and the securing nut from the blade. Once the nut is removed, install the new blade and secure it and re-install the cover.

Installation Instructions

John from Stevensville, MD

replacing the fan on a convection oven (fan was making a vibration noise)

This was the first time replacing the fan. It is a lot easier to work in the oven compartment with the oven door removed, only two screws on the door and the hinges were released. I found that a couple of the screws were either rusted or stripped so I used a pair of pliers to remove the screws that were holding the diffuser in place. Once there was access to the fan I found that the fan was warped and that the blades were scraping against the back wall of the oven. The next challenge was to remove the retaining nut. I used a sheet metal screw to secure the warped fan to keep it from spinning. once I figured out that you have to turn the retaining nut to the right to loosen, it came off easily. 1/2" socket with extension. When I replace the fan I used two washers for spacers to make sure that the fan would not scrape the wall of the oven. Its been tested many times and the oven does not make that horrible sound anymore. Read more...

Your Price

$12.53

Microwave Oven Combo FAN-CONVCT

PartSelect Number PS10066087

Manufacturer Part Number W10758272

Your Price

$19.55

Microwave Oven Combo HUB BLADE Assembly

PartSelect Number PS1020933

Manufacturer Part Number WB02T10289

Installation Instructions

Calvin from Merced, CA

Replaced the inside frame

I had to take the intire oven apart, back included. Read more...

Your Price

$187.86

Microwave Oven Combo Blower

PartSelect Number PS11752032

Manufacturer Part Number WPW10286217

Your Price

$15.97

Microwave Oven Combo Fan Assembly

PartSelect Number PS3528563

Manufacturer Part Number 5893W3A002D

Installation Instructions

Mike from PINEY FLATS, TN

The fan cover in top of the cooking area was burned.

The original cover was burned and actually caught on fire. Research informed me that food can splatter and stick to the cover. The particle will get hot enough to ignite the plastic cover. I ordered the cover and included the fan since it was so cheap, Replacement was super easy. Done in 10 minutes and made my wife happy. She was ready to buy a new microwave because she thought something was wrong with ours but food splatter was the cause. Parts were less than $10 + $6 shipping. Keep the inside of the microwave clean!! Read more...

Your Price

$185.65

Microwave Oven Combo FAN

PartSelect Number PS8715567

Manufacturer Part Number 00444098

Your Price

$8.19

Microwave Oven Combo Microwave Cooling Fan Blade

PartSelect Number PS3528615

Manufacturer Part Number 5900W1A007C

This cooling fan blade is for microwaves. Cooling fan blade attaches to the shaft of the cooling fan motor and rotates to blow air over the magnetron.