Quick Question!

Have you ever purchased from PartSelect.com before?

Popular Westinghouse Stove Parts

Your Price
$33.65
PROBE,OVEN TEMP
PartSelect Number PS11731755
Manufacturer Part Number 316490003
The temperature sensor measures approximately 9 inches long. It sends the temperature up to the electronic control. Over time this can become weak and might be sending the wrong temperature signal. If you notice that your oven is not producing enough heat, it could be because the sensor has failed. This part is located at the back of the oven, and is held in place by a few screws and a wire harness. These will need to be removed. The sensor can be slid out from the hole. The new one simply slides into place.
Fixes these symptoms
Little to no heat when baking
Oven is too hot
Oven not heating evenly

See more...
Installation Instructions
john from spring, TX says,

oven temp not consistent with setting
took off back cover and unplugged old unit and installed new unit. oven probe was not the issue. probally control panel malfunction of readings. will continue using oven temperatue gauge inside to g...read more

Your Price
$28.35
Natural Gas to Liquid Propane Conversion Kit
PartSelect Number PS2351422
Manufacturer Part Number GRLP3
This kit is used to convert your appliance to liquid propane.
Fixes these symptoms
No Symptoms for this part
Installation Instructions
Denny from Bishop, CA says,

Bought a new gas oven that did not come with a propane conversion kit.
I followed the simple instructions that were included in the kit. I started by replacing the 5 orifices on the top burners. The orifices are well labeled with numbers and colors. Next, I tightened the...read more

Your Price
$8.35
Anti-Tip Kit
PartSelect Number PS3655242
Manufacturer Part Number 316112005
The anti-tip bracket kit comes with one metal bracket and two installation screws, and is sourced directly from the genuine manufacturer. It prevents the freestanding oven, range, or stove from tipping when force or weight is applied to an open oven door. The bracket is secured to the floor and wall and fits over the rear leveling leg in the back of the appliance, in a cutout specifically designed for the anti-tip bracket. This part is very essential to the safe operation of the appliance. Failure to install the bracket properly can result in the oven tipping or falling and causing injuries.
Fixes these symptoms
No Symptoms for this part
Installation Instructions
Brian from Panama City Beach, FL says,

anti-tip bracket not installed
I was selling my home and did not realize that the anti-tip bracket was not originally installed. A home inspection caught the problem and the buyers required that I install one. I could not find th...read more

Your Price
$23.65
Light Bulb Lens
PartSelect Number PS2349721
Manufacturer Part Number 318406100
The Frigidaire light bulb lens covers the interior light bulb in an oven. No tools are necessary to replace this item. After unplugging the appliance, slide off the wire bracket to remove the existing light bulb lens. Be sure to remove all broken glass, if applicable, before installing the new lens. It is recommended to check the state of the light bulb while the lens is off. This part is made of glass. The lens is a genuine Frigidaire part, sourced directly from the manufacturer, and is sold individually.
Fixes these symptoms
No Symptoms for this part
Installation Instructions
Jim from Harrison, MI says,

Lower baking element would not heat up.
Your online instructions said to remove the two screws and pull out the heating element about 3 inches and disconnect. When I did this the element came out but not where it was connect to the wire., I...read more

Your Price
$36.26
RACK
PartSelect Number PS1765356
Manufacturer Part Number 316496201
Fixes these symptoms
No Symptoms for this part
Installation Instructions
Albert from Havertown, PA says,

Needed an extra rack to bake more bread
I opened the door of the gas range and slid the rack in. No one can do this! I am amazing....read more

Your Price
$8.93
Rear Drawer Glide
PartSelect Number PS977753
Manufacturer Part Number 316407400
This rear drawer glide, also known as a storage drawer glide, is used in ranges. This helps hold the front side of the storage drawer and allows the drawer to easily slide in and out of the range. If your glide is damaged or missing, replacing it could solve any difficulty using the drawer. First, remove the storage drawer and locate the rear glide on the side. Next, remove the glide by taking out the screws. Replace new glide by placing tabs into the cut-out. If you are replacing both rear drawer glides, then repeat the same on the other side. Refer to the diagram provided by the manufacturer for further installation instructions and guidance.
Fixes these symptoms
Door won’t close


Installation Instructions
robert from orange, CT says,

no display on display module
check for power in to the module,when it had incoming power,order new module,jnstalled it and walah done....read more

Your Price
$8.93
Front Drawer Glide
PartSelect Number PS977752
Manufacturer Part Number 316407301
The front storage drawer glide on your range is mounted on the side of the cabinet. The purpose of the drawer glide is to support the storage drawer from the front. If your front storage drawer glide is damaged or missing, or your storage drawer does not close properly, you should consider replacing the drawer glide. This product is sold individually. This part is approximately 2 inches in length, and 1 inch in width. The front drawer glide is made of white plastic. Many of our customers have rated this repair as easy. The storage drawer also uses a rear drawer glide, which you can find by searching part 977753.
Fixes these symptoms
Door won’t close


Your Price
$5.35
Steel Washer
PartSelect Number PS436497
Manufacturer Part Number 316008401
This steel washer is also known as the range washer and is used on your oven door. The measurements for the steel washer are a three quarter inch outer diameter, and a one quarter inch inner diameter. This washer is an OEM part, made of steel, which is sourced directly from the manufacturer. This specific steel washer is used with your range, to secure the inner and outer door together and to secure the oven door handle back in place. Users have ranked this repair as a simple installation that should take you less than fifteen minutes to complete.
Fixes these symptoms
No Symptoms for this part
Installation Instructions
KELLY from LAKELAND, FL says,

Handle on oven door broke
called around and way to much money for repair man as well as parts from local appliance repair store. They wanted 10.00 for a screw that we got from you for $3.00 same as all the other parts saved o...read more

Your Price
$96.24
Bake Igniter
PartSelect Number PS2364063
Manufacturer Part Number 316489403
The oven burner igniter simply ignites the gas so it can heat the oven burner. The igniter does this by drawing electrical currents through the oven safety valve to open it. If the element shortens out, is no longer glowing, or is only glowing red or orange, replacing the igniter is the solution. You will need a wire splicing tool to do this repair. First, disconnect the wire harness from the igniter by removing the access panel on the rear of the stove. Next, access the front of oven and take out the racks before removing the bottom of the oven. For the rest of the installation instructions refer to the diagram provided by the manufacturer. Remember to unplug your oven from the power source before beginning this project.
Fixes these symptoms
No Symptoms for this part
Installation Instructions
Sparky from ACCOMAC, VA says,

Stovetop worked, oven did not.
First, remove the warming drawer. This allows access to the igniter's plug. Unplug the igniter. The rest of the job is performed within the oven. Remove the bottom (1/4 inch socket). Then remove the n...read more

Your Price
$33.99
Door Handle
PartSelect Number PS1528360
Manufacturer Part Number 316456901
Screws are not included.
Fixes these symptoms
No Symptoms for this part
Installation Instructions
Melinda from Three Rivers, MA says,

Rusted leveling foot
I couldn't unscrew the leveling foot because it was rusted and corroded. The bracket holding it was easy to remove so I took the bracket with the corroded foot off and replaced it with the new foot an...read more

Popular Westinghouse Stove Models

Below are the most popular Westinghouse Stove models we have. Enter your model number in the search box to find your model.