Whirlpool Trash Compactor Switches

Your Price

$63.90

Whirlpool Trash Compactor Directional Switch

★★★★★

17 Reviews

PartSelect Number PS11744742

Manufacturer Part Number WP777811

The function of the directional switch on your trash compactor is to ensure the ram lowers to compress your trash, then returns to the top position. If your trash compactor does not complete this task, will not stop at the end of the compacting cycle, or is noisy during operation, you may need to replace the directional switch. Be sure to disconnect your trash compactor from the power source before completing this repair. This is a fairly easy repair. After you open the control panel of the compactor, all you will need to do is unplug the old switch from the electrical wires, and plug the new switch in.

Fixes these symptoms

Compactor ram gets stuck
Doesn’t stop at end of compacting cycle
Noisy
See more...

Installation Instructions

Scott from Indianapolis, IN

Trash Compactor ram wouldn't lower

I pulled the trash compactor out from under the counter.

I took out the four screws that kept the top cover in place to expose the ram.

The gear shafts were turning but the ram would not lower, at first I though the ram drive bolts were stripped and it wouldn't engage the shaft. Then I realized there was a mechanical directional\limit switch at the top that controlled the power and direction the gear shafts were turning, this switch was broken.

Just had to take off the front plate that was held on by a number of screws and replace the switch that was held on by two more screws. It had five wires attached to it, the new switch was clearly labeled as to which color wire went where. Read more...

Your Price

$105.03

Whirlpool Trash Compactor Switch-off

★★★★★

9 Reviews

PartSelect Number PS11723073

Manufacturer Part Number W10813586

Used with trash compactors.

Fixes these symptoms

Doesn’t stop at end of compacting cycle
Won’t start
See more...

Installation Instructions

John from Sandy, UT

motor would not stop at end of cycle

Remove compactor drawer
Remove screws holding compactor to counter
screw in adjustable feet a short distance
slide compactor out far enough to unplug
loosen top screws that hold tiedown strips and move tie down strips out of way
remove two phillips screws on control panel
push control panel assymbly up and out of front of compactor
remove and replace wires one at a time onto new switch
remove two phillips screws on old switch and removeswitch.install new switch with same screws
install front switch assy by inserting in front panel of compactor and pushing down untill two holes match up for phillip screws.
install screws
realign both tie down straps and tighten screws
plug in compactor
push compactor back into place
level compactor with adjustable feet
replace tiedown screws to underside of counter
replace compactor drawer
push on/off switch to on. push start switch to start compactor.
watch as compactor stops at end of cycle. Hurrah!! Read more...

Your Price

$102.34

Whirlpool Trash Compactor Rotary Switch Kit

★★★★★

19 Reviews

PartSelect Number PS382679

Manufacturer Part Number 675382

The rotary switch kit is also known as the start switch or the on and off switch, and is used to power on your trash compactor. The function of the rotary switch kit is to control the electrical power that is going into your trash compactor. This process happens when the switch sendsvoltage to the motor to start the compacting cycle. If your switch is broken the trash compactor will not start. A multimeter test can be performed to test the switch for continuity. The rotary switch kit will come with an on and off rotary switch, and two chrome knobs.

Fixes these symptoms

Doesn’t stop at end of compacting cycle
Won’t start
Won’t stay on
See more...

Installation Instructions

Edward from Deerfield Beach, FL

Change out defective switch

Pulled out compactor drawer and removed same, slid the compactor cabinet out and unpluged the appliance. Removed the two phillips head screws to release the control panel. lossened the locking nut from switch. matched the switches to be sure parts were the same,switched the wires to the new switch and reinstalled.replaced phillips screws, all Done !!! Read more...

Your Price

$34.06

Whirlpool Trash Compactor Light Switch

★★★★★

2 Reviews

PartSelect Number PS11742478

Manufacturer Part Number WP4387911

The light switch terminal is used in refrigerators and freezers to allow you to see inside your appliance by turning on when the fridge door is open and turning off when the door is closed. This part is 1.12 inches in length, 1 inches in width, and 1.75 inches in height. It weighs 0.026 pounds. If your light switch terminal is damaged or the light does not turn on when fridge door is open, replacing the light switch terminal can fix the problem. As a safety precaution, remember to unplug your fridge from the power source before beginning this installation. Refer to the manual provided by the manufacturer for further installation instructions and a detailed guide.

Fixes these symptoms

Light not working
See more...

Installation Instructions

Darlene from Holland, MI

Light switch broke on refridgerator door.

I measured the part then looked for a similar switch that might work. I was so happy to find the exact part we needed for our 24 year old refridgerator!! I was so impressed with your slection of parts and best of all I had the part in 2 days! You are in my "favorites" just in case I need you again!

Thank you Read more...

Your Price

$48.36

Whirlpool Trash Compactor Safety Switch

PartSelect Number PS405439

Manufacturer Part Number 9871829

Fixes these symptoms

Won’t start
See more...

Your Price

$89.47

Whirlpool Trash Compactor Switch, Rotary Start-run

PartSelect Number PS11747583

Manufacturer Part Number WP9871971

Your Price

$78.06

Whirlpool Trash Compactor Switch-off

PartSelect Number PS11750906

Manufacturer Part Number WPW10242556

Installation Instructions

billy from HOUSTON, TX

My compactor is over 35 years old. Needed rebuild. Noisy. Quick cycle. Overload.

Replaced the bearing assembly at the base of both ram screws (worn out and noisy)
Replaced the drawer switch in the lower back (broken)
Replaced the top up/down switch (old and faulty)
Replaced the nylon ram nuts.
Replaced the control panel on/off/start switch.
Replaced the chain, and chain gear set.
Replaced the motor.
Replaced both sets of drawer rollers.
Final cost in parts - $450 - new compactor $1100. Works like new.
Had to be creative in the 2 drawer switch as they are now longer offered for sale. Found suitable replacements.

This may be my last chance at repairing this. Read more...

Your Price

$210.38

Whirlpool Trash Compactor On/off/start Switch

★★★★★

2 Reviews

PartSelect Number PS11731350

Manufacturer Part Number W10856868

This part activates your trash compactor.

Installation Instructions

Gerald from Vermilion, OH

on-off buttons not functioning

ordered the part from part select and received in 3 days.
removed the faceplate (2 screws)
removed the switch assembley (2 screws)
took wires off old switch, and placed on the new.
replaced all the screws
Bingo, works great.
Saved $150 labor and service call. Read more...