Whirlpool Dryer Circuit Boards and Touch Pads

Your Price

$125.13

Timer

★★★★★

34 Reviews

PartSelect Number PS11749831

Manufacturer Part Number WPW10185982

This dryer timer is used to control the unit's cycles by regulating the length of time that power is directed to each setting.

Fixes these symptoms

No heat or not enough heat
Shuts off too soon
Timer will not advance
See more...

Installation Instructions

Eugene from CRUGER, MS

Dryer would not heat

Repair was very easy only took about ten minutes Read more...

Your Price

$136.02

Timer

★★★★★

11 Reviews

PartSelect Number PS11749833

Manufacturer Part Number WPW10185992

Fixes these symptoms

Timer will not advance
Will not shut off
See more...

Installation Instructions

Rodney from NEWNAN, GA

The Dryer had simply quit turning off: either by moiture sensor or by timer. The timer knob would no longer advance.

I looked up the likely causes on this website and came up with two most likely causes: bad fuse ($10) or a bad timer assembly ($85). Since I suspected the timer assembly might be more likely cause but the fuse was relatively cheap, I went ahead and purchased both of those so I'd likely be able to fix it. Got the parts in 2 days, First I installed the fuse assembly using the video from this site as a coach. Took me maybe 5 minutes to replace, quite easy actually. Put it back together and tested to see if it had fixed the problem. It had not. So I replaced the timer assembly. I used the youtube videos of that for some coaching preparation. Again it was easy as pie. Took me 5 minutes to remove the old one and replace with the new one. Put it all back together and tested it. SUCCESS! that fixed it! So.. for about $100 in parts, I fixed it. The service call alone would have cost $150 not including parts, so I saved at least $150 doing it myself! Your diagnostic help advise was absolutely vital to enabling me to diagnose and find the right replacement parts! THANK YOU! Read more...

Your Price

$110.89

Timer - 230V 60Hz

★★★★★

6 Reviews

PartSelect Number PS11749827

Manufacturer Part Number WPW10185972

This dryer timer is used to control the unit's cycles by regulating the length of time that power is directed to each setting.

Fixes these symptoms

No heat or not enough heat
Timer will not advance
Will not shut off
See more...

Installation Instructions

Rufus from REDDING, CA

No function

Replaced timer Read more...

Your Price

$169.02

Timer

★★★★★

2 Reviews

PartSelect Number PS11754717

Manufacturer Part Number WPW10436303

Fixes these symptoms

Timer will not advance
See more...

Your Price

$451.88

Electronic Control Board

PartSelect Number PS11749572

Manufacturer Part Number WPW10174745

Fixes these symptoms

Will Not Start
See more...

Installation Instructions

Scott from Manassas, VA

Dryer indicated error codeF23 after 1 minute of operation

I followed the test guidance on the tech sheet (located behind the front lower cover). According to it, F23 was a short in the outlet thermistor. The thermistor tested good along with all the other replaceable temp related devices.
I then started a general diagnostic following the steps in the tech guide. The dryer failed a motor control step which indicated a bad control board. Replacing the board (after it arrived) took less than 5 minutes and was 100% plug and play.
The most difficult part was ensuring that the test leads for the multimeter were on the correct test points. If you are not confident in using a multimeter, I would not recommend you perform this level of repair. Read more...

Your Price

$118.66

Timer - 60Hz

★★★★★

2 Reviews

PartSelect Number PS11749825

Manufacturer Part Number WPW10185970

This dryer timer is used to control the unit's cycles by regulating the length of time that power is directed to each setting.

Fixes these symptoms

No heat or not enough heat
Will not shut off
Will Not Start
See more...

Installation Instructions

Thomas from W LAFAYETTE, IN

The dryer drum was running and there was no heat.

I will be very honest. I watched between 5 and 10 youtube videos. I did a lot of circuit checking with a Simpson Meter. One video suggested checking the timer. The meter indicated an open circuit on the heater terminals for the timer Sure enough when I opened up the time you could see arcing on the contacts of the timer switch for the heater part of the circuit. Read more...

Your Price

$136.43

Timer - 230V 60Hz

★★★★★

4 Reviews

PartSelect Number PS11749829

Manufacturer Part Number WPW10185976

This dryer timer is used to control the unit's cycles by regulating the length of time that power is directed to each setting.

Fixes these symptoms

No heat or not enough heat
See more...

Installation Instructions

James from CANTON, GA

Dryer not heating.

Checked all possible items with a multimeter. Of course the last item I checked was the one that did not show a closed circuit.. the timer. Ordered the part with one day shipping and it arrived the next day. Install took just a few minutes and it was fixed. Online videos are a great tool for diagnosing and repair. Do yourself a favor and do it yourself and save a lot of money. Read more...

Your Price

$175.57

Dryer Timer Control

★★★★★

8 Reviews

PartSelect Number PS11749830

Manufacturer Part Number WPW10185981

60hz

Fixes these symptoms

No heat or not enough heat
Timer will not advance
See more...

Installation Instructions

Joseph from LINCOLN, RI

timer control would get stuck

Bought the part and removed 10 screws unplugged the wiring and applied it to the new part. Reassembled, done.
Super easy, works great! Read more...

Your Price

$413.47

Electronic Control Board

★★★★★

3 Reviews

PartSelect Number PS11748354

Manufacturer Part Number WPW10111606

This part is located in the control panel. It senses the resistance change and opens and closes a relay sending power to the dryer heater.

Fixes these symptoms

Will Not Start
See more...

Installation Instructions

Carrie from WEXFORD, PA

F01 Error Code

At first, my dryer would just make a clicking noise but would not start. After some research, I unplugged it to try to 'reset' it and after that, I noticed the F01 error. Some quick research on the internet you can find the source of the error is a failed machine board. Some DYI people soldered the part where the connection broke but, I chose to just buy the new part. I was pretty confident where the error was and did not want to waste time and the cost of a repair man visit. I followed the instructions on the most thorough YouTube video and removed the top of the dryer, took pictures of the control board wires and began the removal process. The insertion fo the new board took about 1 minute. All in all, the physical work took my husband and I about 10 minutes. Research was about an hour and I had the part shipped overnight. This website has saved me hundred of dollars and lots of wasted time trying to find a repair man when Covid has made it difficult to get anyone to your house. Our washer sprung a leak during the initial lockdown and we were able to fix that ourselves as well.
My only comment about the part is that the chime at the end of the cycle is very different. I have yet to find out if I can change that but it is not too bothersome.
I love this website and its products! Read more...