Whirlpool Dishwasher Hoses and Tubes

Your Price

$45.30

Drain Hose

★★★★★

(6)

PartSelect Number PS11756139

Manufacturer Part Number WPW10545278

This part is used to drain water from your dishwasher.

Fixes these symptoms

Leaking
Not cleaning dishes properly
Not draining
See more...

Your Price

$30.52

Drain Hose

★★★★★

(21)

PartSelect Number PS2358130

Manufacturer Part Number 8269144A

This drain hose is 6 and 1/2 feet.

Fixes these symptoms

Leaking
Not cleaning dishes properly
Not draining
See more...

Installation Instructions

Jason from Lugoff, SC

Drain hose was leaking.

Switched circuit breaker off.
Removed kick panel.
Removed the dishwasher from counter.
Disconnected drain hose from the pee trap.
Disconnected drain hose from pump.
Installed new drain hose.
Reinstalled dishwasher in counter.
Connected hose at the pee trap.
Turned power back on. test for leaks by running a cycle.
Reinstalled kick panel. Read more...

Your Price

$49.39

Faucet Adapter

★★★★★

(21)

PartSelect Number PS11751238

Manufacturer Part Number WPW10254672

The faucet adapter for your portable dishwasher or washing machine attaches to the faucet and allows you to connect the machine to the tap. Before you install the faucet adapter on your taps, be sure that it fits the coupler on your dishwasher or washer. As per the factory, this is used for faucets with inside or outside threads. For female connection (outside) just remove the washers. This adapter is approximately 1 inch in length, and slightly less than one inch in diameter. This adapter comes with two different thicknesses of rubber washer. You will not need to use both so be sure to determine which thickness works best for your tap before installing it.

Fixes these symptoms

Leaking
Will not fill with water
See more...

Installation Instructions

Stephen from Enfield, CT

faucet attachment would not sit correctly in hose connector to portable dishwasher. Received machine second hand. Could not find a replacement faucet adapter. So ordered new one and hose plus connector.

Turned machine on side. Removed two casters with Wonder Tool prybar. Then used it to remove plastic push screws holding cardboard bottom cover. Unscrewed water hose. Used screwdriver to remove clamp on drain hose. Stood machine upright, opened door. Unscrewed two screwsfrom tabs into woodblock top. Slid top forward and removed it. Cut plastic hose retainer. Removed hose assembly. Installed new hose by reversing steps. Used a new wire strap to hold hoses in place on top corner of machine. Read more...

Your Price

$70.63

HOSE

★★★★★

(2)

PartSelect Number PS3651318

Manufacturer Part Number W10445975

Fixes these symptoms

Leaking
See more...

Installation Instructions

sharon from LAS VEGAS, NV

rat got under dishwasher and chewed water lines, grommet

saw big hole in first (main) hose - got replacement at local hardware thinking it was the only problem - it wasn't - turned on the water and noticed another leak so ordered hose from parts select - fast delivery - installed 2nd hose but still a leak so ordered grommet from parts select - again prompt delivery - installed it and voila no more leak -
also checked for rat entry points, plugged those and put down bait - bait wasn't being taken under dishwasher even tho rat reappeared so put a snap trap in back - no luck so far - teachable moment: might have been cheaper to just get another dishwasher as parts are expensive and its difficult to tell extent of damage - luckily i only needed 3 parts = $150 Read more...

Your Price

$71.83

Inlet Fill Hose

★★★★★

(7)

PartSelect Number PS11738178

Manufacturer Part Number W10878507

This fill hose is a genuine OEM replacement part for your dishwasher. The hose is made of black plastic, and is accordion-style, for ease of movement within your dishwasher. To replace the fill hose, you will need a 1/4 inch nut driver, Channellock pliers, and a Phillips screwdriver. Replacing this part will require some disassembly, such as removing the water inlet valve from the fill hose, and the clamps which secure the hose in place. Reuse your existing clamps when securing your new fill hose in place.

Fixes these symptoms

Leaking
Will not fill with water
See more...

Installation Instructions

J from HARPERSVILLE, AL

Water leak

I watched the instructional videos that showed how to replace the inlet fill hose/water inlet a couple of times. The repair was exactly as shown. No trouble at all. Read more...

Your Price

$53.04

Manifold

★★★★★

(5)

PartSelect Number PS11752851

Manufacturer Part Number WPW10323424

Also known as a water supply tube which is used for your middle spray arm.

Fixes these symptoms

Leaking
Not cleaning dishes properly
See more...

Installation Instructions

Irl from EMMITSBURG, MD

manifold wore out did not hold water anymore

remove one philips screw take out manifold replace with new one put screw back in and we are done not mechanically difficult by any means Read more...

Your Price

$39.37

Middle Wash Arm Tube

★★★★★

(9)

PartSelect Number PS11741343

Manufacturer Part Number WP3378144

This tube attaches to your middle spray arm.

Fixes these symptoms

Leaking
Not cleaning dishes properly
See more...

Installation Instructions

Pamela from St. Petersburg, FL

The upper wash assembly broke off. Then the middle wash arm tube just literally fell apart. I was concerned at first at the design changes, but I can see the wisdom in them. It only took a few minutes to repair and now it's like a new machine again. All for $20 instead of $500 or more for a new

First I took out the upper rack, unscrewed the old remains and screwed in the new part. Next, I took out the upper rack, turned it over, removed the old hanger (no longer necessary with newly designed part), unscrewed the other part, and screwed on the new part. So easy! And one more thing-I ordered my part on a Fri. and it was on my porch by the following Tues. Now THAT'S service! - Pam Read more...

Your Price

$60.25

Drain Hose

★★★★★

(3)

PartSelect Number PS11753695

Manufacturer Part Number WPW10358302

This hose is used to drain the water.

Fixes these symptoms

Leaking
Not draining
See more...

Installation Instructions

Jason from Lugoff, SC

Drain hose was leaking.

Switched circuit breaker off.
Removed kick panel.
Removed the dishwasher from counter.
Disconnected drain hose from the pee trap.
Disconnected drain hose from pump.
Installed new drain hose.
Reinstalled dishwasher in counter.
Connected hose at the pee trap.
Turned power back on. test for leaks by running a cycle.
Reinstalled kick panel. Read more...

Your Price

$145.58

Drain and Fill Hose Assembly

★★★★★

(3)

PartSelect Number PS11751626

Manufacturer Part Number WPW10273574

This part is used for portable dishwashers.

Fixes these symptoms

Leaking
Will not fill with water
See more...

Installation Instructions

Ronald from New Britain, CT

Drain and hose coupler would pop off the faucet under pressure

I removed all the cabinet screws (be careful, they use a special star bit and mine broke so I replaced all the screws with hex head sheet metal screws which was OK).
I then removed the top-very easy, 3 screws.
Disconnected two hoses at bottom of machine, one with a clamp that needed to be unscrewed the other was standard hose attachment. Put a shallow pan under the hose area where you will be removing them. There will be some water. Remove the hose assembly from the special plastic holder on the inside of the cabinet and remove the assembly from the entry point at the rear of the cabinet. Insert the new hose assembly, connecting the hoses first.
Check the old hose to determine roughly where it had been bracketed to the cabinet making sure you will have enough hose to reach your faucet. I left no slack inside the machine beyond the plastic holder. Reassemble the cabinet to the frame loosely screwing it in until all screws are in. The finish tightening them all. Reinstall the top.
Unscrew the old faucet connector and screw in the new one until fully hand tight. If you use a pair of pliers to tighten it more, protect it from the tool buy using a cloth of plastic jar cover remover to prevent damage. Connect the machine to the faucet, plug it in and let her rip. Mine was leak-less but NOTE- I connected it and tested it before re-assembling the cabinet, Otherwise you won't know if your connections were tight until its too late. Read more...