Whirlpool Dishwasher Caps and Lids

Whirlpool Appliance Parts

Popular Whirlpool Dishwasher Caps and Lids

Your Price
$27.59
  In Stock
Whirlpool Dishwasher Rinse-Aid Dispenser Cap
★★★★★
★★★★★
46 Reviews
PartSelect Number PS11746426
Manufacturer Part Number WP8558307
The rinse aid cap (sometimes referred to as the dispenser cap), covers the rinse aid dispenser on the dishwasher door. If your dishwasher will not dispense detergent, or it is leaking detergent, there could be an issue with the rinse aid cap. Check the cap and its gasket for any damage or melting. If the cap has melted or it is not sealing the dispenser properly, the part should be replaced right away. This rinse aid cap comes with the gasket, so you should discard the existing gasket and rinse aid cap at the same time. The repair is relatively straightforward, and requires no tools.
Fixes these symptoms
  • Door latch failure
  • Leaking
  • Not cleaning dishes properly
  • See more...
Installation Instructions
James from Mesquite, TX
Cap came off and melted
Opened door and installed cap. Not much effort. But really got good service from Parts Select. Received order much faster than I had expected. Read more...
Your Price
$29.68
  In Stock
Whirlpool Dishwasher Rinse Aid Cap
★★★★★
★★★★★
15 Reviews
PartSelect Number PS11755938
Manufacturer Part Number WPW10524919
This part holds the rinse aid liquid in the dispenser until the timer activates the rinse cycle.
Fixes these symptoms
Installation Instructions
Kathryn from WINTERPORT, ME
Rinse aid cap was melted when it came out of the designated spot and melted against the heat coil.
Open the washer door, remove old rinse aid cap. Place new cap into designated spot, screw into place. Read more...
Your Price
$27.77
  In Stock
Whirlpool Dishwasher Rinse Aid Cap
★★★★★
★★★★★
29 Reviews
PartSelect Number PS11748135
Manufacturer Part Number WPW10077881
This part holds the rinse aid liquid in the dispenser until the timer activates the rinse cycle.
Fixes these symptoms
  • Door latch failure
  • Leaking
  • Not cleaning dishes properly
  • See more...
Installation Instructions
James from Brandon, FL
Rinse Aid Cap was not secured and during dishwaher run the cap sat on the heating coil and melted.
This is simple, we don't know exactly how, but when we used the dishwasher the cap must not have been twisted correctly, and after the dishwasher shut down we discovered the cap was on the heating coil and melted. I know that it was easy to fix, but the reason I ordered it from PartsSelect was their price was much lower than Kitchen Aids, (the maker), Lowes (where we bought it), and other sites we searched for the part. Read more...
Your Price
$11.10
  In Stock
Whirlpool Dishwasher Rinse Aid Cap
★★★★★
★★★★★
14 Reviews
PartSelect Number PS11741341
Manufacturer Part Number WP3378134
This cap does not require the use of an O-ring seal. The wet agent assembly cap is clear in color and made of plastic. This is a part for your dishwasher. This part may need to be replaced if you notice that your dishwasher is not dispensing detergent, cleaning dishes properly, or has sprung a leak. The cap is found on the inside of your dishwasher door. This is an extremely simple repair that requires no tools. Simply open your dishwasher door, twist the old cap out of place, ensuring no pieces are left behind. Screw your new cap into place.
Fixes these symptoms
  • Leaking
  • Not cleaning dishes properly
  • Not drying dishes properly
  • See more...
Installation Instructions
Louis from Niceville, FL
Water dripped out from the bottom of door.
Diagnosing the problem, i.e. finding the source of the leak, was the hardest part. The best clue was the leak only occurred well into the cycle when the water was hot and steam was coming out the vent. I then assumed there was a bad seal and steam & condensed water was leaking down into the door. I replaced the vent duct & seal, a broken drip cover (an internal part in the door), and replaced a missing rinse aid cap. This stopped the leak. Read more...
Your Price
$31.04
  In Stock
Whirlpool Dishwasher Rinse Aid Cap
★★★★★
★★★★★
28 Reviews
PartSelect Number PS11755939
Manufacturer Part Number WPW10524920
This is a replacement cap for the detergent/rinse aid dispenser. If the rinse aid cap is damaged or missing, you may notice too much rinse aid in the dishwasher. The cap simply screws in to the dispenser, so if your cap is damaged you can simply screw it out, then screw in the new one. The rinse aid cap is approximately 2 inches in diameter and is sold individually. This is an OEM part, directly from the manufacturer.
Fixes these symptoms
  • Leaking
  • Not cleaning dishes properly
  • Not drying dishes properly
  • See more...
Installation Instructions
Donald from MANHATTAN BCH, CA
rinse aid cap came loose and melted in the bottom of the dishwasher
Received the new cap and twisted it into place. Read more...
Your Price
$15.49
  In Stock
Whirlpool Dishwasher Tub Cap
★★★★★
★★★★★
1 Review
PartSelect Number PS11703426
Manufacturer Part Number W10795980
The plastic button covers the sharp ends of screws along the edge of the dishwasher tub. Sold individually.
Fixes these symptoms
Installation Instructions
Royce from GREENSBORO, NC
Dish rack slide arms losing ball bearings
Unscrewed mounting screws, pulled dishwasher out halfway, replaced arms, 4 screws each side .....very simple 30 min tops. Parts perfect and quick delivery! Read more...
Your Price
$29.58
  In Stock
Whirlpool Dishwasher Rinse Aid Cap
★★★★★
★★★★★
19 Reviews
PartSelect Number PS11746567
Manufacturer Part Number WP8564929
This rinse aid cap or fill cap is for your dishwasher and it screws into the jet dry dispenser. Sometimes the cap can become loose and fall out, which can cause it to melt from the heater. If your cap is damaged or missing, this is the part you will need to replace it. It is made of white plastic and is a little more than an inch in diameter. This rinse aid cap is sold individually.
Fixes these symptoms
  • Leaking
  • Not cleaning dishes properly
  • Not drying dishes properly
  • See more...
Installation Instructions
Joan from Glendora, NJ
the rinse aid cap fell into the bottom of the dishwasher and got burnt by the coils. It was letting the rinse aid empty out every time I used the dishwasher because the seal was broken.
I just put the new cap on and that was it. Read more...
Your Price
$23.49
  In Stock
Whirlpool Dishwasher Dispenser Cap
★★★★★
★★★★★
6 Reviews
PartSelect Number PS11746156
Manufacturer Part Number WP8533380
This is the cap for your rinse aid dispenser.
Fixes these symptoms
Installation Instructions
Brian from Marion, IA
Couldn't find the part anywhere, but...
PartSelect found the right part for me on the first try. I had scoured the web looking for this particular drying agent cap. Even Sears said I'd have to order the entire dispenser assembly - $$$!

PartSelect found just the cap I needed at a much better price.

Fantastic service. Shipping was faster than promised. I can't say enough good things about them!
Read more...
Your Price
$42.77
  In Stock
Whirlpool Dishwasher Cover
PartSelect Number PS11755008
Manufacturer Part Number WPW10455272
Fixes these symptoms
Your Price
$43.64
  In Stock
Whirlpool Dishwasher Rinse Aid Cap - Gray
★★★★★
★★★★★
8 Reviews
PartSelect Number PS11755941
Manufacturer Part Number WPW10524922
This is the replacement rinse aid cap for your dishwasher. It is made of gray plastic and is approximately 2 inches in diameter. This rinse aid cap screws into the rinse aid assembly and prevents leaks. Sometimes the cap can become loose and fall out, which can cause it to be melted by the heater. If your cap is damaged or missing, this is the part you will need to replace it. This rinse cap is an authentic OEM part sourced directly from the manufacturer and is sold individually.

Related Whirlpool Dishwasher Parts