Washer Drawers and Glides

Videos!

Your Price

$42.19

Washer Upper Drum Glide

★★★★★

32 Reviews

PartSelect Number PS470317

Manufacturer Part Number 5303937139

The upper drum glide is attached to the front panel of your dryer, you can locate it by removing the top portion of your dryer. The drum glide allows the drum to rotate with ease and little sound. The front upper felt glide pad with three nylon glides also includes adhesive, essential for mounting accurately. For this project you will need a putty knife, Phillips screwdriver, and a wire brush. This repair is meant to fix issues such as an abnormal amount of noise or the dryer not tumbling as it should. Consider replacing your belt at the same time if you have a dryer more than 5 years old, as it is likely worn.

Fixes these symptoms

Marks left on clothes
Noisy
See more...

Installation Instructions

Matthew from Portland, OR

Clothes getting scorch marks, drum noise

First and foremost, I read the repair reviews here at parts source and found that a) Other people had the same symptoms, b)following their repair tips made it super easy.
What I would add to previous reviews is to pull the front off or the little acces grill in back and check to see what kind of belt you have. According to the model #, It showed the wide flat belt when in fact I had the smaller ribbed belt. Glad I checked before ordering.
A few things that will make your life easier is once you have the old upper guide/seal removed, put down the glue then use several med sized plastic spring clamps to hold the seal in place while the glue sets up, (@ 20-30 min). Their cheap and you should have some around anyway. When replacing the seals I would go ahead and replace the belt too. It's cheap and if your machine is 5+ yrs old probably is worn. Total cost of repair was about $60 (inc shipping). Took about 1 hr 20 min total time. Most of that time was scrapping the old seal material/ glue off the dryer front. Actual disassembly and repair maybe 1/2 hour. Other little tip is the clips for the lid of dryer is to use a flat screwdriver and gently push straight in until it's compressed enough to release the lid, it will pop up when pushed in far enough. That one took me a while to figure out.
Thanks to Part Select for such a helpful site. My dryer is like new again. Read more...

Your Price

$42.19

Washer Slider

★★★★★

1 Review

PartSelect Number PS10060062

Manufacturer Part Number W10734521

This clutch slider kit is genuine OEM replacement kit that fits in various models of washing machine. It is a part of the transmission system in your washer which is responsible for controlling the movement of the agitator during the wash and spin cycles. The assembly includes the clutch band, slider, and lock ring. The kit helps to regulate the speed and direction of the agitator or drum. It allows the machine to start and stop spinning smoothly, as well as change speeds as needed during the wash and spin cycles. If the clutch slider kit has worn or damaged components, it can lead to problems like difficulty starting or stopping the machine, excessive noise during operation, or failure to spin properly.

Fixes these symptoms

Cycle Not Advancing
Noisy and Marks Left on Clothes
Spinning Issues
See more...

Your Price

$62.65

Washer Drawer Assembly

★★★★★

2 Reviews

PartSelect Number PS12585054

Manufacturer Part Number 5304514792

Fixes these symptoms

Leaking
See more...

Installation Instructions

Jeff from MCCORDSVILLE, IN

Original Drawer Assembly bottom broke apart leaking water down the front of washer.

Very simple, removed Drawer Assembly from unit. Removed detergent bowl and front cover. Installed front cover and detergent bowl on replacement Drawer Assembly. Returned installed replacement Drawer Assembly on unit. Read more...