Toro Lawn Tractor Parts | Same Day Shipping | Millions of Parts
You are logged in as a customer LOG OUT

Hello!

You're visiting the PartSelect site in U.S.

Would you like to shop on the Canadian site?

Stay on this site
Go to Canadian site

Popular Toro Lawn Tractor Parts

Fitting-Grease – Part Number: 302-5
Your Price
$3.08
Fitting-Grease
PartSelect Number PS8949362
Manufacturer Part Number 302-5
Fixes these symptoms
No Symptoms for this part
Nut-Lock, Ni – Part Number: 3296-29
Your Price
$3.08
Nut-Lock, Ni
PartSelect Number PS9276436
Manufacturer Part Number 3296-29
The Ni Lock Nut (Nylock Nut) is a Silver, 5/16x18, individually sold metal nut. It can be adjusted and replaced using a wrench or socket and torque wrench to the manufacturer specfications, and is used to secure the sheer pin in place on the augur. These nuts are a one time use part due to their locking mechanism. You'll know the nut has broken because the augur will not spin, and this is when the part should be replaced. Customers found this to be an easy repair.
Fixes these symptoms
No Symptoms for this part
Plug-Spark – Part Number: 796112S
Your Price
$4.41
Plug-Spark
(1)
PartSelect Number PS9140427
Manufacturer Part Number 796112S
This part is the replacement spark plug for your engine. It measures approximately 2.5 inches by 1 inch. The spark plug creates the spark that ignites fuel in your engine during the combustion process. Over time, spark plugs can become worn and can go bad, which will prevent the engine from firing. You can test your spark plug for continuity with a multimeter, and inspect it for corrosion if you suspect the spark plug has gone bad. This is an OEM part sourced directly from the manufacturer and it is sold individually.
Fixes these symptoms
Will Not Start


Installation Instructions
David from KNOXVILLE, TN says,

Replace carburetor
Loosened engine cover and moved out of the way
Removed air intake and filter
Loosened and disconnected gas line to carburetor
Unscrewed carburetor and disconnected from throttle arm
read more

Gasket--Rocker Cover – Part Number: 272475S
Your Price
$6.08
Gasket--Rocker Cover
PartSelect Number PS8941245
Manufacturer Part Number 272475S
This OEM Gasket Rocker Cover, which can also be called the Valve Cover Gasket, is used to provide a seal between the valve cover and engine. This is a gray-colored part, measuring 5 1/2 x 4 Inch, and it is sold individually. It can be attached using a wrench or socket. Note: this part also requires a Torque Wrench. When installing, tighten and torque in alternating patterns, following the manufacturer specficiations. You will know when it needs to be replaced when there is oil leaking around the valver cover gasket, which is a sign the part is broken, likely due to simple wear and tear or constant dryness. To make sure you are purchasing the right part, check your model number. Customers rated this repair as easy.
Fixes these symptoms
No Symptoms for this part
Installation Instructions
FRANK from EASTANOLLEE, GA says,

Screw can out of the carburator throttle baffel and stuck in the exhaust valve
No compression. Removed the cylinder head. freed the screw, checked the valve to see if it still sealed. Turned the head over with the valves in it, install a spark plug, fill the head dome with gas a...read more

Seal-O Ring – Part Number: 691917
Your Price
$4.28
Seal-O Ring
(1)
PartSelect Number PS9294749
Manufacturer Part Number 691917
The Seal-O Ring, also known as the gasket, is red in color, made of rubber, and is an OEM part that requires some skill to replace. This part is designed to create a seal between the carburator and manifold, to prevent air from entering. If your engine loses power, creates a hissing noise, or if the gasket appears damaged or your engine running improperly it may be time to replace the part. If you run the engine and spray the outside of the carburator with soapy water, you can test whether or not the gasket is leaking by listening to the sounds produced. If the sound smooths out then you've found your leaky gasket. Damage may occur over time, especially if the part dries out, and make the part appear stretched or worn out. When making this medium-difficulty repair, make sure the new gasket is fitted properly between the carburetor and intake manifold.
Fixes these symptoms
No Symptoms for this part
Installation Instructions
FRANK from EASTANOLLEE, GA says,

Screw can out of the carburator throttle baffel and stuck in the exhaust valve
No compression. Removed the cylinder head. freed the screw, checked the valve to see if it still sealed. Turned the head over with the valves in it, install a spark plug, fill the head dome with gas a...read more

Washer-Flat – Part Number: 3256-24
Your Price
$3.08
Washer-Flat
PartSelect Number PS8954417
Manufacturer Part Number 3256-24
Fixes these symptoms
No Symptoms for this part
Seal--Oil (PTO Side) – Part Number: 795387
Your Price
$7.63
Seal--Oil (PTO Side)
(2)
PartSelect Number PS9151828
Manufacturer Part Number 795387
This OEM Seal-Oil (PTO Side), also called the Oil Seal, is a Black, Nitrile Rubber, 2/14 O.D., individually sold part which is installed using a Seal Puller. Customers rate the installation difficulty as Medium. This part provides a seal around the crank shaft and engine block. When installing onto the engine block around the crank shaft, use something that makes contact around the entire seal, like a large socket or pipe, and tap into place evenly, ensuring that the housing is clean and dry. If the part is broken, likely due to fatigue, there will be leaking oil, and this part should be replaced using the model number on the original part to confirm it is the right fit for your model.
Fixes these symptoms
No Symptoms for this part
Installation Instructions
rodney from MUSCATINE, IA says,

governor not working
Had to pull the engine off the rider mower. Drained the oil took shield off the flywheel. Set it upside down on a 5 gal bucket. Took a 7/16 hand wrench to remove governor lever from bottom of engine...read more

Nut-Hex – Part Number: 3219-6
Your Price
$3.68
Nut-Hex
PartSelect Number PS9275990
Manufacturer Part Number 3219-6
Fixes these symptoms
No Symptoms for this part
Key-Flywheel – Part Number: 222698S
Your Price
$3.08
Key-Flywheel
(1)
PartSelect Number PS8925657
Manufacturer Part Number 222698S
Fixes these symptoms
No Symptoms for this part
Gasket--Intake – Part Number: 692137
Your Price
$3.08
Gasket--Intake
(1)
PartSelect Number PS9294790
Manufacturer Part Number 692137
This manufacturer-certified Gasket-Intake, more commonly known as the Intake Gasket, is a gray, 3 x 2 inch, individually sold part which can be installed using a Wrench or Socket and a torque wrench. This part provides a seal between the caburator and intake manifold, and can be easily installed. Just ensure you are tightening to the manufacturer specfications when repairing this part. If your engine is getting more air than fuel and appears under-powered, it may be a sign this part needs to be replaced. Try spraying a mixture of soapy water at the base of the carburator at the intake manifold with the engine running, and if the engine runs more smoothly then you have discovered the problem.
Fixes these symptoms
No Symptoms for this part
Installation Instructions
FRANK from EASTANOLLEE, GA says,

Screw can out of the carburator throttle baffel and stuck in the exhaust valve
No compression. Removed the cylinder head. freed the screw, checked the valve to see if it still sealed. Turned the head over with the valves in it, install a spark plug, fill the head dome with gas a...read more