Tappan Dryer Hardware
- Search your model number to find:
- Genuine OEM parts guaranteed to fit
- Free manuals and guides
- Repair instructions and videos
Popular Tappan Dryer Hardware
Tappan Dryer Screw
Removed belt from motor
Needed to lift up top of dryer
Inserted flathead screwdirver in front under top to push in two metal clips holding top down
Lifted up top of dryer
Removed 2 screws holding on front of dryer
Removed front of dryer
Broke Door Switch removing front of dryer. I should have depressed the metal sides in and pulled switch through hole.
Instead, I tried to remove the leads. This broke the fragile prongs.
Started dryer (with belt removed so drum doesn't spin)
Verified ignightor came on every heating cycle
Gas turned on properly
Gas turned off after 90 seconds
Gas never came back on
Indicitive of bad coils
New coils solved the problem
Replaced door switch and lint trap cover in the process. Read more...
PartSelect Number PS417463
Manufacturer Part Number 131302800
This is a replacement screw for your washer or dryer. The screw is approximately half an inch in length and is a Phillips-head screw. It screws in from the outside of the drum, into the vane/baffle. The main reason you would replace this screw is if the old screw is missing or damaged. This part is sold individually and is an OEM part sourced directly from the manufacturer.
Installation Instructions
Edward from Baltimore, MD
Drying too slowly
Removed access plate from back bottom leftRemoved belt from motor
Needed to lift up top of dryer
Inserted flathead screwdirver in front under top to push in two metal clips holding top down
Lifted up top of dryer
Removed 2 screws holding on front of dryer
Removed front of dryer
Broke Door Switch removing front of dryer. I should have depressed the metal sides in and pulled switch through hole.
Instead, I tried to remove the leads. This broke the fragile prongs.
Started dryer (with belt removed so drum doesn't spin)
Verified ignightor came on every heating cycle
Gas turned on properly
Gas turned off after 90 seconds
Gas never came back on
Indicitive of bad coils
New coils solved the problem
Replaced door switch and lint trap cover in the process. Read more...
Tappan Dryer Screw
PartSelect Number PS417085
Manufacturer Part Number 131168200
Sold individually.
Installation Instructions
Glenn from Fort Worth, TX
Dryer squealed loudly
First, I removed the top panel which is held on at the front by pressure clips. Second, I removed the entire front panel which entailed removing 2 screws and 2 wire couplings. Third, I removed the 3 screws on the inside center of the drum which turned out to be unnecessary. Fourth, I slid the drum forward in order to access the rear bearing. Lastly, I replaced the entire bearing assembly including the shaft, bracket, bearing, grounding ball and clip. Again, probably not needed but I had ordered the parts in advance in preparation for the worst.
Read more...
Tappan Dryer Steel Washer
quick delivery and easy repair ... like new again .
would use you again Read more...
PartSelect Number PS436497
Manufacturer Part Number 316008401
This steel washer is also known as the range washer and is used on your oven door. The measurements for the steel washer are a three quarter inch outer diameter, and a one quarter inch inner diameter. This washer is an OEM part, made of steel, which is sourced directly from the manufacturer. This specific steel washer is used with your range, to secure the inner and outer door together and to secure the oven door handle back in place. Users have ranked this repair as a simple installation that should take you less than fifteen minutes to complete.
Installation Instructions
KELLY from LAKELAND, FL
Handle on oven door broke
called around and way to much money for repair man as well as parts from local appliance repair store. They wanted 10.00 for a screw that we got from you for $3.00 same as all the other parts saved over 70.00 dollars.quick delivery and easy repair ... like new again .
would use you again Read more...
Tappan Dryer Screw - Flat Head
PartSelect Number PS975699
Manufacturer Part Number 134156200
Sold individually.
Installation Instructions
Theresa from New York, NY
Bottom door inge had gotten rusted so door was not closing.
Removed the old screws and old hinge. Put on the new hinge with new screws. Tightened 'em up and we were good to go. Pretty boring and basic. But beats the hell of not having the washer door close!
Read more...
Tappan Dryer Screw
PartSelect Number PS417260
Manufacturer Part Number 131243700
Sold Individually. Pan Head Screw - 8-18ab X 0.375
Tappan Dryer Screw - Sold Individually
PartSelect Number PS417147
Manufacturer Part Number 131205300
Tappan Dryer Bracket Screw
PartSelect Number PS417148
Manufacturer Part Number 131205400
Sold individually.
Fixes these symptoms
- Noisy
- See more...
Installation Instructions
MIKE from MASSAPEQUA PARK, NY
dryer was squealing loadly
took off face of dryer, removed drum 4 screws removed two srews holding bearing and shaft ,replaced shaft bearing and shaft . Just for preventive maintenance i replaced idleling arm and dryer belt. I lined everything up replaced drum used shop vac to clean lint and dust from all parts replaced face of dryer and boom i got a btand new dryer
Read more...
Tappan Dryer Screw
PartSelect Number PS417652
Manufacturer Part Number 131382300
This screw is a little over an inch long.