Refrigerator Drip Bowls
Find your partEnter your model number or a part number and click "Search"
Here is an example model number plate:
Popular Refrigerator Drip Bowls
PartSelect Number PS3487846
Manufacturer Part Number WR17X12873
Refrigerator Dispenser Drip Tray
PartSelect Number PS11766752
Manufacturer Part Number W10909034Genuine OEM part
Evaporator Drip Tray
PartSelect Number PS11756735
Manufacturer Part Number WPW10614158This is the replacement evaporator drip tray for your refrigerator. It is made of white plastic and is approximately 19 inches by 9 inches. The evaporator drip tray sits below the evaporator to collect dripping water. If the drip tray is damaged, you may notice that your refrigerator is leaking. Because it is made of plastic, the drip tray can eventually develop a crack. You will need to pull out the refrigerator from the wall, and take off the bottom panel on the back of your refrigerator in order to access the drip tray for replacement. This is an OEM part sourced directly from the manufacturer.
Jerrel from REDDING, CA
Cracked Evaporation tray was leaking water on kitchen floorI emptied refrigerator contents and tilted the refrigerator to the right so as to access the metal panel upon which the evaporation tray was resting. The metal panel is on the left side underneath the refrigerator and the evaporation tray is resting on the panel. I removed 4 screws that were holding the metal panel, pressed down on the panel, slid out the old, cracked plastic evaporation tray, inserted the new plastic evaporation tray, raised the metal panel to its original position, replaced the 4 screws, being careful not to pinched the water line that feeds the ice-maker. VOILA! Un-tilt the frig and re-stock it. It took a day for the temperature to stabilize, due to tilting, I think. New tray $45. Read more...
PartSelect Number PS3487856
Manufacturer Part Number WR17X12884
Drip Tray - Gray
PartSelect Number PS11753651
Manufacturer Part Number WPW10356019
Evaporator Drip Pan
PartSelect Number PS964475
Manufacturer Part Number WR17X11843This is the replacement evaporator drip pan, also known as the drain trough, for your refrigerator. You will find the drip pan in the fresh food section of the refrigerator. It collects any water that may drip off the evaporator. If your drip pan is rusted, or is leaking into the refrigerator, you may need to replace it. Before you install the new drip pan, you will want to thoroughly clean the areas around the evaporator to ensure there is no more remaining rust or debris. This part is sold individually and is an OEM part sourced directly from the manufacturer.
Gregory from El Dorado, AR
Trough Drain pan was rustedFirst I removed the shelving from the refrigerator side I then removed the cover to the refrigerator condenser which consisted of a plastic cover and a styrofoam inner chamber cover. The Condenser is held in place with two stainless phillips head screws. I removed the screws and gently pulled the condenser forward so that the Drain pan could be easily removed. The drain pan is made out of thin sheet metal with a galvanized coating that will not hold up it will start rusting in a short time. I inspected the drain pan cleaned it up with a little Muretic acid and it had too many rust holes so I couldn't repair it. I ordered a new Drain pan on Part Select and when it came in I washed it and dried it completely then I sprayed it with Cold Galvanizing compound with zinc particles. You can get this from Home Depot on the spray paint isle. Hopefully the spray Galvanizing will keep it from rusting in the future and leaking inside the refrigerator. The Trough Drain Pan should have been made of Stainless sheet metal or plastic I don't really know why they used the galvanized coated pan. Everything went back together in reverse with no problems. Hopefully this drain pan will last longer than the first drain pan because it was only 4 years old. I remember when the older refrigerators would run for decades. Read more...
PartSelect Number PS11756974
Manufacturer Part Number WPW10655368
David from Traverse City, MI
Drip pan in the back bottom was cracked during shipping and leakedWe had periodic leaks from under the Unit from new, could never figure out where it was coming from. Finally as it began to cause damage to surrounding cabinets, we took the back off and found the multiple cracks in the drip pan. Someone had hand trucked it from the wrong side! It was difficult to figure out the fan removal (it sits in the pan) but push the top forward and pull the bottom back and the fan came out. Then the pan was simple to remove / replace, by reversing the removal procedure, the fan was re installed. Read more...
Dispenser Overflow Grille - Black
PartSelect Number PS11739642
Manufacturer Part Number WP2207109BThis dispenser grille catches any overflow from the ice/water dispenser.
Bryan from Sammamish, WA
Broken ice dispenser, hard-water deposit stained grillTo replace the coupling, remove the ice holder (in the freezer door), then use a socket driver to remove both the bolts and cap above the drive shaft. Remove the old coupling from the top of the drive shaft and replace with the new coupling, then reinstall removed parts. Read more...
PartSelect Number PS8758405
Manufacturer Part Number WR17X20452