Dual Infinite Switch Kit 903057-9010

Hello Tiana, thank you for your question. First, this part is a substitution part, so you will have to break the shaft off to the desired length. Here are the instruction for the switch itself. Black. wire with a jumper feed will feed both P-2's. Orange # 18 gauge wire goes to the pilot and the # 4 switch connection. Red wire #16 gauge jumper is from the # terminal to the inner element connection. This is the same side that hooks to the limiter which the other end of the limiter is a brown # 16 gauge wire going to the #2 connection of the R.F. Sw. The other side of the switch has a red # 16 gauge wire hooks to it from the jumper to L-2 connection of the RT.R. Sw., jumping to the Lt. rear sw.(@L_2) finally dead front at (ending) the P-1 connection on the Lt. front switch. The limiter has a black #18 gauge wire connected to it that is a jumper series to all limiters on the same connection. The limiter has a brown,gray or an orange #18 gauge feeding one side of the hot surface l.e.d. indicator bulb. There is a red # 16 gauge wire that goes to the P1 connection of the switch, opposite of the brown wire on #2 connection going to the limiter.Good luck with your repair!

Hello Julie, thank you for your question. Yes, this is the correct Dual Infinite Switch Kit PS981086. We are pleased to have been able to help.