Bottom Panel 316400601

Hello Tpm, thank you for your question. Unfortunately, now that that is baked on there, it will be next to impossible to remove. You're best bet is to replace the oven bottom, which is Bottom Panel Part Number: 316400601 . I hope this helps!

Hello Dan, thank you for contacting us. Yes, it should just be those 2 screws then it will pull out. Good luck with the repair!

Hi Doris, Thank you for your inquiry. Before you begin any repair please unplug the appliance from the electrical outlet or turn the circuit breaker off. First, remove the two screws at the back of the panel. If the range has a convection fans with cover over them, then this cover will also need to be removed. There should be a screw on the top and the bottom of the fan cover that needs to be removed and then you can pull the convection fan cover out. Lift up on the back of the bottom oven panel and carefully pull back on the panel until you release the front lip of the panel from under the front of the oven cavity. This is a tight fit. It may take some patience to remove the bottom panel. It may take several tries to get the front lip released if you have a convection fan on the back wall of the oven cavity. Once you release the front lip of the bottom panel, you can pull it out of the range and work the new one in. Start working the new one in at the same angle as you pulled the old one out. Back of the panel tilted evenly up. Work the front lip into the front of the frame and then wriggle the new panel into place. Replace the screws in the back of the panel. I hope this helps. Thank you and have a great day!

Hi Janet, Thank you for your question. If aluminum foil melted on the bottom oven panel inside of your oven, there are some things that you can do to try and remove it. Try mixing baking soda and vinegar together in a large bowl. Make sure you add enough vinegar to allow a thin paste to form. Using a dry cloth, spread the paste over the area where the aluminum foil melted and let it set overnight. Use a wet-dry vacuum the next morning to remove any dried baking soda and any loose aluminum foil. Another option to try is to remove the foil by soaking an old towel in water and letting it set overnight. Remove the towel from the oven the next morning and throw it away. Then clean up any bits of foil from the oven. For any foil that is proving too difficult to remove, use a putty knife and try and remove it. If cleaning the bottom panel does not help, the part number listed for it is PS977589. I hope this helps. Thank you and have a great day!

Hello Marlie, Thank you for contacting us. I have researched the model you have provided and have found the part you are looking for is PartSelect Number PS977589. Hope this helps!

Hello George, thank you for contacting us. If you have an order with our company and need to speak about that, you will have to contact our contact customer service by phone or by email at customerservice@partselect.com. Thank you.

Hello, Thank you for your question. You would not need anything else to replace that. Your screws would be- Part #: PS436031, you would need 4 of those. You are able to reuse the screws you have if they are not worn or stripped. We hope this helps.

Hello Ben, Thank you for contacting us. I have researched the model you have provided and have found the part you are looking for is PartSelect Number: PS1991808. Hope this helps!

Good Day Ben. Thank you for your question in regards to your unit (Model Number CGEF4035RWA). The model number you provided is not recognized. Please verify the number you provided us. If it is correct, we recommend contacting the manufacturer and seeing if they could provide you with a part number, and then you are always welcome to check back to see if we carry the part!

Hello Gord, Thank you for your question. The dimensions for the bottom panel is 22.5" x 19". We hope this helps.