Refrigerator Freezer Door Gasket - Black MDS64172918

Hi Melvin, thank you for reaching out. Please follow these instructions. Use a blow dryer to slowly warm the new gasket to remove any creases and bends from shipping. Loosen, but don't remove, the four screws holding the freezer door on. Gently lift up to remove the door and place it on a towel to prevent scratches. Pull up on the gasket to remove it from the channel, your gasket may require you to pull out rather than up to remove it. Thoroughly clean and dry the gasket channel. Lay the new gasket on the door, line up one corner, and push the rubber ridge down into the channel. Once the gasket is seated in each corner, work from the corners toward the center of each side, pressing the gasket into the groove. Run your finger under the outer edge of the gasket to make sure it's sitting flush all the way around. Install the door in reverse order, and you're done! We hope this information helps!

Hi Tim, Thank you for asking. This Gasket is approximately 36" x 24". We hope this helps!