We're sorry, but our Q&A experts are temporarily unavailable.
Please check back later if you still haven't found the answer you need.
16 questions answered by our experts.
< Prev
1
2
Next >
Sort by:
Search filter:
Clear Filter
Your search term must have 3 or more characters.
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Sorry, we couldn't find any existing answers that matched.Try using some different or simpler keywords, or submit your new question by using the "Ask a Question" button above!
Kim Decore
January 29, 2019
Will this part take care of temperature beeping hot on frig
For model number Ffhs2611lwma
Hello, thank you for your question! We would recommend checking the following parts to fix your issue: the defrost thermostat (PS469522), run capacitor (PS3495561), evaporator fan motor (PS11728171), and defrost heater (PS2581596). These are common causes of the refrigerator section being too warm. If the temperature is fine, or all of these parts are testing correctly, you may need to look at the thermister, part PS8760187 as it may be sensing the temperature incorrectly. We hope this helps!
10 people found this helpful.
Was this helpful?
Thank you for voting!
David
July 5, 2021
Refrigerator too warm but when I create a gap between this part and the duct to the freezer it gets too cold. I believe the part has failed, am I right?
For model number CRSH268MWB
Hello David, Thank you for the question. The Damper should open and close on its own to allow the cold air though. If you can manually open and it allows the cold air into the Fresh Food Section, we suggest having it replaced. We hope this helps!
6 people found this helpful.
Was this helpful?
Thank you for voting!
Shane
July 12, 2021
Fridge is beeping and flashing h1. Videos show it should be damping assembly. Thoughts?
For model number FFSS2614QE1A
Hello Shane, Thank you for the question. The error "H1" error code indicates that the refrigerator thinks that the freezer and refrigerator temperatures are too warm. The temperatures are likely too warm. You can check to make sure the Damper is opening and closing properly and allowing the Cold Air to flow. You can also check the Defrost Thermostat Kit. The best way to do this is to remove the thermostat from the refrigerator so you can control the temperature of the sensor. You can let the sensor warm up to room temperature. With the sensor warmed up to room temperature the sensor should read approximately 6.2K Ohms at 68°F. With the thermistor submerged is a glass full of ice water, the sensor should be very close to 32°F which should read approximately 16.3K Ohms. If the values that you are getting are far off from these readings, then the sensor is bad and should be replaced. We hope this helps!
5 people found this helpful.
Was this helpful?
Thank you for voting!
Paul
November 27, 2017
Air damper assembly Electrolux 24230001 how to check out
For model number ffsh2611lwb
Hi Paul, Thank you for the question.If you are asking how to check to see if it is working, you will need to listen for the motor kicking on and off and watch to see if the door is opening. If you are asking how to check out and order the part, There is an add to cart button you can click to add the damper to the cart and proceed with the order. Hope this helps!
4 people found this helpful.
Was this helpful?
Thank you for voting!
Liane
December 19, 2018
Is this damper assembly supposed to close completely? Mine does not close all the way, nor does it seem like it was manufactured to. Part number 242303001
For model number ffhs2622msj
Hello liane, thank you for your question. The damper shouldn't close completely. It should be open slightly to allow some air into the unit. I hope this helps.
2 people found this helpful.
Was this helpful?
Thank you for voting!
Jonathan
February 28, 2019
Will this fit my refrigerator, and will it stop it from being too cold in my refrigerator?
For model number FFSS2614QS6A
Hi Jonathan,
Thank you for your question. Yes, this part is listed under your model number and it is designed to work with your refrigerator. This is one part that is listed to be replaced if the refrigerator is too cold. You will also need to check the defrost thermostat and the electronic control board. I hope this helps. Thank you and have a great day!
2 people found this helpful.
Was this helpful?
Thank you for voting!
Steve
December 30, 2019
I unplugged the damper from the fridge when i plug it back in it makes a sound like it's trying to open. I pressed down on the door and then it will open then shut. Does this mean i should replace the dampener or is it something else that is preventing it from working?
For model number FFSS2614QP4A
Hello Steve,
Thank you for your question. The damper shouldn't close completely. It should be open slightly to allow some air into the unit. We hope this helps!
1 person found this helpful.
Was this helpful?
Thank you for voting!
Dustin
June 30, 2021
Does this come assembled or would i have to assemble this part first?
For model number FFSS2625TSO
Hi Dustin,
Thank you for your question. Yes, the damper control assembly will be assembled. If you would like to place an order for it, you may order it either online or by calling our customer service line and anyone will be happy to assist you. We hope this helps! Good luck with the repair!
1 person found this helpful.
Was this helpful?
Thank you for voting!
Alberto
January 11, 2023
What are all the symptoms if the flaffer in the damper control assy remain closed
For model number 243303001 damper control assy
Hi Alberto, thank you for reaching out. If you put your hand up to the damper, you should be able to feel the cold air coming through from the freezer. Mechanical dampers usually have a slide gate, which will open or close the damper. Therefore, the damper is not working if you do not feel cold air coming from the vent. It may be stuck closed, and you may be able to move it. We hope this information helps!
Was this helpful?
Thank you for voting!
Jamison
March 19, 2023
My fridge is too cold, freezing some items in it. Could this be this part?
For model number FFHS2611PFEA
Hello Jamison, thank you for your query. We would recommend checking the following parts to fix the issue: defrost thermostat kit, part number PS469522, thermistor assembly, part number PS8760187, damper control assembly, part number PS8746718, and evaporator fan motor, part number PS12728811. We hope this helps, good luck with this repair!
Average Repair Rating: 3.8 / 5.0, 2 reviews.
What's this?
< Prev
1
Next >
Sort by:
Search filter:
Clear Filter
Your search term must have 3 or more characters.
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Sorry, we couldn't find any existing installation instruction that matched.
Side by Side Freezer/Refrigerator - Refrigerator not cooling
While waiting for parts I removed the control and side panels, placed duct tape partly over the hole to the freezer to allow fridge cooling and left the panels lay inside plugged up while I monitored the fridge temp. This worked until the parts arrived.
1. Remove 3 hex screws holding (underneath) the front control panel to the top of the fridge. 2. Remove 2 screws holding the left side assembly. The control panel and the side assembly come down as 1 L shaped piece. 3. Unplug the large control cable and the small cable then remove the entire assembly. Note the position of the freezer sensor extending into the freezer. Separate the control panel from the side assembly to access the cable bundle. 4. Remove and replace the Damper Control Assembly. Note: You can remove the complete old styrofoam (glued in place) or cut the tape holding a 2 part styrofoam section that holds the damper in place and only replace the upper part. Be sure to tape the 2 styrofoam parts back together. Make sure the freezer sensor is placed properly on the Damper assy. 5. Remove and replace the old thermistor assembly, secure the wiring bundle and reattach the control panel to the side panel. 6. Place the entire assembly back inside, plug up the cables. 7. While supporting both panels insert the freezer sensor in the proper position and replace the 3 screws securing the control panel then the 2 screws securing the side panel. Check that the side panel is flush against the side after installation. 8 Wait about 12 hours for the temperature to stabilize.
Removed the nut screws holding on the controls on the fridge side. Swapped out the old damper control for the new. Just need to be sure to get the new assembly in the same way the old one came out -- including placement of the freezer sensor control (separate part from the assembly). Replaced the control unit and damper worked and now my fridge is the right temperature! One other item -- when diagnosing the problem with a warm fridge, most newer fridges have a self testing method via the digital temperature controls. Find your Service Data Sheet for instructions. This would have saved me time from using my multimeter testing various components.
Lyman from LEXINGTON, KY
Difficulty Level:
Really Easy
Total Repair Time:
15 - 30 mins
Tools:
Nutdriver
10 of 12 peoplefound this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
< Prev
1
Next >
Customer Reviews
Average Rating:
★★★★★
★★★★★
11 Reviews
4.6
Filter By Rating:
5 Stars
8
4 Stars
2
3 Stars
1
2 Stars
0
1 Star
0
< Prev
1
2
Next >
Sort by:
Search filter:
Clear Filter
Your search term must have 3 or more characters.
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Sorry, we couldn't find any existing reviews that matched. Try using some different or simpler keywords.
★★★★★
★★★★★
Frederick H - September 28, 2022
Verified Purchase
Fridge repair
The part was exactly what I needed to fix my fridge
★★★★★
★★★★★
Michael S - September 28, 2021
Verified Purchase
Works fine
So far so good.
★★★★★
★★★★★
Jimmy T - June 24, 2021
Verified Purchase
okay
worked
★★★★★
★★★★★
Brad F - February 24, 2021
Verified Purchase
Easy installation and fixed the issue
The part was shipped quickly and properly packaged. The installation was straightforward and done in a few minutes, even though I'm probably the least mechanically-inclined person on the planet. Fixed the issue that we were having. Very satisfied.
★★★★★
★★★★★
Del A - September 1, 2020
Verified Purchase
Perfect fit, easy install
Fast ship, came as a complete field replaceable unit. Literally "plug and play".
★★★★★
★★★★★
Sonne W - May 12, 2020
Verified Purchase
Easy repair and part fit perfectly
Shipping was fast easy to order fridge is working again
★★★★★
★★★★★
Lisa P - July 31, 2019
Verified Purchase
Great part, exactly what I needed.
The part was exactly what I needed to repair the refrigerator. It is now working in great condition! Thank you for the fast shipping!
★★★★★
★★★★★
Frederika P - June 1, 2019
Verified Purchase
Works wonderfully
Awesome
★★★★★
★★★★★
Randall C - February 19, 2019
Verified Purchase
Parts good and worked but paid extra for a fast delivery and took a week to get when it was supposed to be 2-3 days
Parts good and price was good. Delivery options need to be looked into.
★★★★★
★★★★★
Aleyda V - January 29, 2019
Verified Purchase
Fits perfectly
The part arrived on time. It fit my frigidaire like a glove.
< Prev
1
2
Next >
Model Cross Reference
This part works with the following models:
PartSelect Number: PS8746718
Manufacturer Part Number: 242303001
With the Fix app, you can quickly and easily find information on your appliance, along with videos and articles to help you fix it.
"Like magic. I took a picture of the model number on my refrigerator, and the app identified it right away … Very convenient. I'm impressed." ★★★★★ - Clever Jeff
★★★★★
You added 1 item to your cart
✖
$
Qty:
Total item(s) in cart:
Order Subtotal
$
*Taxes and shipping will be applied during checkout
Your Subscriptions
