PANEL-FACIA 00683956

Hello Robert, thank you for the question. We are providing you some instructions that will help you replace panel facia. Use the following instructions: 1. Turn off the dishwasher. 2. Open the dishwasher door and remove the screws securing the outer door to the inner door. 3. Close the door and pull the outer panel down and out to remove it. 4. Now open the door again and remove the screws at the top and side that attach the control panel. 5. Remove the screws under the control panel. 6. Press the side mounting bracket and remove the housing. 7. Remove the control panel. 8. Remove the buttons from the old panel and attach to the new one. 9. Follow the procedure in reverse to assemble. We hope this information helps!

Hi Andrew, Thank you for your question. The part number for the handle is PS8722221. We hope this helps!

Hello Dean, Thank you for contacting us. While we do not show if this part comes with instructions, we have found the following installation information for you: First remove the screws holding the inner door panel to the outer door panel using a Torx screwdriver. Then lift the door back up into place and then remove the outer door panel by lifting it upward and out from the bottom and pulling it off. Remove the screws from the inner door panel that holds the facia panel to the inner door, and then remove the panel from the inner door. Remove the screws on the lower edge of the panel, and then press the side locking tabs to remove the panel from the mounting bracket. Transfer each button assembly carefully to the new panel (the on/off button is held on with a hinge and you need to remove it from the slot and lift it out), and then using two thumbs lift both tabs that hold the handle to the panel and push it out. Now replace the on/off button by lowering it down into the hinge until it locks and push it back into place. Slide the handle into the control panel by matching the tabs and cutouts and press the handle in. Now replace each of the smaller buttons by snapping each one into the hinges and pushing them in place. Line up the panel on the mounting bracket, lock it into place with the side tabs and replace the screws at the front. Last, attach the screws holding it to the inner panel, and attach the screws that hold the outer panel to the inner panel. We hope this helps you.