( Grid squares measure 1x1 inch )

Get in touch, we're here to help!

Open until 12am EST

customerservice@partselect.com

Electrical Door Lock

★★★★★
★★★★★
5 Reviews

Get this part fast! Average delivery time for in-stock parts via standard shipping: 1.8 days.

 Fits your WAS20160UC!
 Fits your WAS20160UC!
PartSelect Number PS8727513
Manufacturer Part Number 00612148
Manufactured by Bosch
Product Description

Electrical Door Lock Specifications

If the door on your washing machine will not close, or if your washer will not start, there could be a problem with the locking system. This electrical lock is designed to firmly hold the door of your appliance closed while it completes both the washing cycle and the spin cycle. If this lock is broken or damaged and the door cannot close, it will prevent the washer from operating. This door lock assembly is approximately 3 inches long, and 5 inches wide. You will need a screwdriver to successfully replace the locking mechanism on your washing machine.
How Buying OEM Parts Can Save You Time and Money play video

How Buying OEM Parts Can Save You Time and Money

Troubleshooting
This part fixes the following symptoms:
Lid or door won’t close | Will Not Start
This part works with the following products:
Washer.
This part works with the following products:
Bosch.
Part# 00612148 replaces these:
AP4355295, 00611090, 611090, 612148
Questions and Answers

We're sorry, but our Q&A experts are temporarily unavailable.
Please check back later if you still haven't found the answer you need.

1 question answered by our experts.
    Sort by:
    Sorry, we couldn't find any existing answers that matched.Try using some different or simpler keywords, or submit your new question by using the "Ask a Question" button above!
    Steve
    February 22, 2020
    I’m getting code f34. I replaced the electrical door lock and it did not fix it. What else could it be?
    For model number Was25560UC
    Hello and thank you for writing. The error code "F34" means "The (upper) oven cooling fan air switch not detected". The problem can be a bad air switch, a bad blower fan motor, a clogged vent line or broken wires. The air switch and fan motor can be tested for continuity. We hope this helps. Please contact us anytime if you require further assistance.

    Was this helpful?
    Thank you for voting!
      Customer Repair Stories
       Average Repair Rating: 2.8 / 5.0, 1 reviews. What's this?
        Sort by:
        Sorry, we couldn't find any existing installation instruction that matched.
        the door would not latch because the door latch mechanism was broken
        i first looked on line to see if there was a video to replace the door switch/lock mechanism. i found one for a different model and it mostly applied. the steps to complete the repair are as follows: 1. disconnect the plug, 2. open the door and remove the garter spring that holds the door seal boot onto the front of the washing machine. 3. roll the boot back to access the door lock. 4. unsnap the retaining bracket. there is limited but enough space to grab the switch. a plastic retaining bracket snaps to the back of the switch. it's a little tricky to pull the switch out but it's possible to unsnap the bracket. 5. pull the switch out of the square hole in the washer front. there aren't any screws on this model washer. the switch is held in place by a groove on one side that slips over the front and the plastic retaining bracket. 6. disconnect the electrical plug. again, there's not much space. the clip that retains the plug in on the switch and it must be pushed out of the way before the wiring plug will come out. it's tough because of the limited space. 7. pull the switch out. 8. remove the manual unlock pull rod from the old switch. install the new switch by 1. reconnecting the electric plug. 2. push the switch into the square hole on the washer front. it goes in on an angle so the groove in one side of the switch goes over the washer front. 3. reclip the plastic retaining bracket. 4. replace the manual unlock rod. this is tricky because it's all be touch. 5. replace the door seal boot. pull it over the ring on the washer front. make sure the seal is properly set in the groove around the door opening. 6. reinstall the door seal garter. this is really tough because the spring is pretty stiff and the wire will want to pull the boot from the groove. i first put the garter about 3/4 of the way around and used some spring clamps to hold it in position while i pulled the spring over the rest of the way. the spring only goes on the boot closest to the door. and that's all there is. i also ordered the "latch" but it was not needed.
        • Don from MADISON, CT
        • Difficulty Level:
          A Bit Difficult
        • Total Repair Time:
          30 - 60 mins
        • Tools:
          Pliers
        10 of 12 people found this instruction helpful.
        Was this instruction helpful to you?
        Thank you for voting!
          Customer Reviews
          Average Rating:
          ★★★★★
          ★★★★★
          5 Reviews
          4.8
          Filter By Rating:
          • 5 Stars
            4
          • 4 Stars
            1
          • 3 Stars
            0
          • 2 Stars
            0
          • 1 Star
            0
            Sort by:
            Sorry, we couldn't find any existing reviews that matched. Try using some different or simpler keywords.
              Model Cross Reference
              This part works with the following models:
              PartSelect Number: PS8727513
              Manufacturer Part Number: 00612148
              Brand
              Model Number
              Description
              Bosch
              WAS20160UC
              Washer - WASHER
              Bosch
              WAS20160UC/01
              Washer
              Bosch
              WAS20160UC/16
              Washer
              Bosch
              WAS20160UC/18
              Washer
              Bosch
              WAS20160UC/20
              Washer
              Bosch
              WAS20160UC/23
              Washer
              Bosch
              WAS20160UC/28
              Washer
              Bosch
              WAS24460SA
              Washer - Bosch Washing Machine Model WAS24460SA/18 Parts
              Bosch
              WAS24460UC
              Washer - WASHER
              Bosch
              WAS24460UC/01
              Washer
              Bosch
              WAS24460UC/16
              Washer
              Bosch
              WAS24460UC/18
              Washer
              Bosch
              WAS24460UC/20
              Washer
              Bosch
              WAS24460UC/23
              Washer
              Bosch
              WAS24460UC/28
              Washer

              Get in touch, we're here to help!

              Open until 1am EST

              Contact Customer Service