On/Off Button - Black 00427746

1. Open the door and remove the three lowest screws on each side.
2. Close the door and remove the front panel by pulling down and out.
3. Remove the four screws that hold the fascia in place.
4. Partially open the door and remove the fascia by lifting and wiggling at both ends.
5. Remove the broken button. Mine was in ... Read more two pieces.
6. Snap the new button in place.
7. Replace the fascia, taking care to get each tab back in its slot.
8. Replace the four screws holding the fascia in place.
9. Replace the front panel by pressing it in and up.
10. Replace the screws holding the front panel in place.

Used a screwdriver. That was it. Conformation email had instructions that I used. Easy breezy...

Removed 6 screws from front metal cover, removed 4 screws holding panel-facia in place. installed new "buttons" on new panel-facia, snapped into place, then place panel-facia into place and attached with 4 screws. using 6 screws attached front cover to dishwaher door. Have to remove cover in order to remove the panel-facia. very easy job ... Read more and one person can do it. you do need the star design bit for the screw heads

take six screws out of the front panel and remove the panel. remove four screws from the top handle cover that are underneath than remove it and put the buttons in the new piece . than snap the new handle cover back in place and put the four screws that hold it back in. put the front panel back on and you are done