SWITCH 808136601

Hi Juan, Thank you for your question. Before installing the light switch, please unplug the stove from the electrical outlet. Then, remove the screws securing the back access panel and set the panel aside. Once the back panel has been removed, you will then need to lift-up the cooktop and the panel underneath. To lift the cooktop, lift-up on the front corners and make sure your cooktop locks open. Two legs in the front should lift-up with the cooktop that will support it. With the cooktop lifted, remove the screws securing the panel to the stovetop. To lift the panel, remove the legs securing the cooktop and lift the panel up so it is up over the stove pipe found in the left rear corner. Do not remove the panel from the cooktop, put the panel behind the legs to secure it. The light switch is located in back right corner. There is a long bar connected to the light switch. You will need to bend the bar to pull it, so when you release the switch, you can slide it forward. To remove the light switch, unplug the wire harness connected to it. Then use a flathead screwdriver to release the tabs holding it in place. With switch released, you can grab the rod and pull the switch forward. Remove the old switch from the rod and insert the rod into the hole on the switch. Then feed it back to the hole in the back and lock it into place. Then follow the steps in reverse to put the stove back together. If you have any questions, please let us know. We are open 7 days a week. We look forward to hearing from you!

Hi Karol, thank you for getting in touch. Please follow the given instructions to change the switch: 1) Unplug the range. 2) Remove the control knobs. 3) Remove the top panel retainers, lift the top panel off and disconnect the oven control wire harnesses. 4) Remove the screws securing the control bracket. 5) Disconnect the surface element wire harnesses and set the bracket aside. 6) Open the oven door and remove the screws securing the bottom of the control cover. 7) Remove the screws on top and set the cover aside. 8) Remove the screws securing the main top assembly. Note the position of the wire harnesses, then lift the main top assembly up and pull it forward to remove. 9) With the oven door open, use needle nose pliers to depress the tabs to release the old door switch from the front panel. Note the location of the wires on the switch, then disconnect them. We hope this is helpful!

Hello Erin, thank you for asking. Before installing the light switch, please unplug the stove from the electrical outlet. Then, remove the screws securing the back access panel and set the panel aside. Once the back panel has been removed, you will then need to lift-up the cooktop and the panel underneath. To lift the cooktop, lift-up on the front corners and make sure your cooktop locks open. Two legs in the front should lift-up with the cooktop that will support it. With the cooktop lifted, remove the screws securing the panel to the stovetop. To lift the panel, remove the legs securing the cooktop and lift the panel up so it is up over the stove pipe found in the left rear corner. Do not remove the panel from the cooktop, put the panel behind the legs to secure it. The light switch is located in back right corner. There is a long bar connected to the light switch. You will need to bend the bar to pull it, so when you release the switch, you can slide it forward. To remove the light switch, unplug the wire harness connected to it. Then use a flathead screwdriver to release the tabs holding it in place. With switch released, you can grab the rod and pull the switch forward. Remove the old switch from the rod and insert the rod into the hole on the switch. Then feed it back to the hole in the back and lock it into place. Then follow the steps in reverse to put the stove back together. If you have any questions, please let us know. We are open 7 days a week. We look forward to hearing from you!

Hello Erin, Thank you for contacting us. From researching this part number, the method to install the new switch should be the same. We hope this helps.